damienmaguire / Stm32-vcuLinks
A Vehicle Control Unit for Electric Vehicle Conversion Projects based on an STM32F107. Software based on the Openinverter Project.
☆188Updated this week
Alternatives and similar repositories for Stm32-vcu
Users that are interested in Stm32-vcu are comparing it to the libraries listed below
Sorting:
- Very hacky project that talks to the Nissan Leaf BMS (aka LBC) and to the VW CAN bus☆61Updated 7 months ago
- Main firmware of the Huebner inverter project☆179Updated 4 months ago
- OpenSource Control Unit for the Nissan Leaf Gen 1 and Gen 2 inverter☆61Updated 4 years ago
- Reverse Engineering of the Tesla 10Kw charger and development of an open source control board☆126Updated 4 years ago
- Generalized Electric Vehicle Control Unit☆117Updated 3 years ago
- 7th generation GEVCU source code☆26Updated 2 weeks ago
- Eagle schematics of inverter main board, sensor boards and gate drivers☆73Updated 3 years ago
- Development of a control unit to permit Chademo 50kw DC Fast Charging on converted electric vehicles☆45Updated 4 years ago
- Fully Open CCS Charge Controller Interface with QCA7005 PLC modem☆88Updated 5 months ago
- Software for Damien Maguire's CHAdeMO controller☆23Updated 5 years ago
- Opensource controller for the Lexus GS450H Hybrid inverter and gearbox☆21Updated 4 years ago
- A tool to allow configuration and operating of openinverter systems for electric vehicles over a CAN connection☆23Updated last month
- Reverse engineering of the on board charger (OBC) used in MG Electric Vehicles☆20Updated 3 months ago
- CAN bus analyzing and simulation GUI tool for Windows.☆75Updated last month
- microRusEfi board for rusEfi ECU☆84Updated 2 months ago
- ☆20Updated 7 months ago
- Collection of CAN logs from different electric vehicles☆37Updated 2 weeks ago
- STM32 with QCA7005 as CCS charge controller☆90Updated 2 months ago
- Prius Gen 3 buck/boost converter charger controller - buck mode charging☆14Updated 5 years ago
- Bootloader project to update for example STM32F107 / GD32F107 chips☆17Updated last year
- Open-Source: Modular BMS based on LTC68XX & STM32 MCU for up to 400V EV battery pack☆276Updated 4 years ago
- Hardware - dingoPDM is an open source, affordable automotive PDM (Power Distribution Module). Pre-assembled and tested units are availabl…☆89Updated last month
- ☆177Updated 7 years ago
- Monitor Canbus traffic☆131Updated 5 months ago
- Common structures and functionality for CAN libraries☆141Updated last year
- Hardware - CAN enabled small input / output expansion board. Switch panels, steering wheel buttons/knobs, etc.☆44Updated 2 months ago
- 16s / 100A Battery Management System☆173Updated last year
- Empty Openinverter project to start your own☆15Updated last year
- ☆17Updated 3 years ago
- Speeduino compatible engine control unit (ECU) based around black STM32F407VET6 board.☆50Updated last year