damienmaguire / BMW-PHEV-BMSLinks
Reverse engineering of the BMW PHEV battery pack bms CAN bus data
☆10Updated last year
Alternatives and similar repositories for BMW-PHEV-BMS
Users that are interested in BMW-PHEV-BMS are comparing it to the libraries listed below
Sorting:
- Reverse Engineering of the BMW SBox for use in ev conversion projects☆14Updated 2 years ago
- OpenSource Control Unit for the Nissan Leaf Gen 1 and Gen 2 inverter☆62Updated 4 years ago
- Reverse engineering of the on board charger (OBC) used in MG Electric Vehicles☆20Updated 5 months ago
- ☆20Updated 9 months ago
- Hacking and reverse engineering of the VW Onboard AC chargers☆15Updated 2 years ago
- Opensource controller for the Lexus GS450H Hybrid inverter and gearbox☆21Updated 4 years ago
- ☆10Updated 2 years ago
- leaf spline revers engineering☆14Updated 5 years ago
- Collection of CAN logs from different electric vehicles☆39Updated this week
- C# app that shows a simple way to calculate the CRC byte used by some canbus frames in Nissan Leafs☆12Updated 11 years ago
- Software for Damien Maguire's CHAdeMO controller☆23Updated 5 years ago
- ☆44Updated 3 years ago
- Prius Gen 3 buck/boost converter charger controller - buck mode charging☆14Updated 5 years ago
- Very hacky project that talks to the Nissan Leaf BMS (aka LBC) and to the VW CAN bus☆64Updated 9 months ago
- BMW CANbus gateway emulator & proxy☆22Updated 5 years ago
- Development of a control unit to permit Chademo 50kw DC Fast Charging on converted electric vehicles☆45Updated 4 years ago
- Redacted code for Rust-based Charge Port Controller☆11Updated 5 years ago
- Wideband Lambda Controller with Bosch CJ125☆43Updated 2 years ago
- SIMPBMS code for I3 Modules☆47Updated 2 years ago
- Open Inverter - Alternative Web Interface☆34Updated 4 years ago
- A tool to allow configuration and operating of openinverter systems for electric vehicles over a CAN connection☆23Updated this week
- ESP32 Based Chademo implementation☆19Updated last year
- Tips and tricks on repairing the fragile ZE0 LEAF PTC heater☆11Updated 3 years ago
- Wideband Lambda Controller with Bosch CJ125 and CAN-Bus Interface☆34Updated last year
- Can based decoding of VW bms data☆39Updated last year
- Web interface for Huebner inverter☆36Updated last year
- ARCHIVE: Lebowski controller IC 2.A1 source code and (short) explanation☆19Updated 5 years ago
- An ESP32 based BMS master for CAN based remote boards. Makes use of SimpBMS code for decoding the module data messages.☆16Updated 2 years ago
- Hardware - CAN enabled small input / output expansion board. Switch panels, steering wheel buttons/knobs, etc.☆48Updated last month
- arduino library to read data on V.A.G. FIS line (3lb, data,enable,clock)☆11Updated 4 years ago