jsphuebner / stm32-car
Very hacky project that talks to the Nissan Leaf BMS (aka LBC) and to the VW CAN bus
☆60Updated last month
Alternatives and similar repositories for stm32-car:
Users that are interested in stm32-car are comparing it to the libraries listed below
- A Vehicle Control Unit for Electric Vehicle Conversion Projects based on an STM32F107. Software based on the Openinverter Project.☆146Updated last month
- Software for Damien Maguire's CHAdeMO controller☆21Updated 4 years ago
- OpenSource Control Unit for the Nissan Leaf Gen 1 and Gen 2 inverter☆62Updated 4 years ago
- Development of a control unit to permit Chademo 50kw DC Fast Charging on converted electric vehicles☆43Updated 4 years ago
- Reverse engineering of the on board charger (OBC) used in MG Electric Vehicles☆13Updated last year
- ESP32 Based Chademo implementation☆15Updated 7 months ago
- Collection of CAN logs from different electric vehicles☆31Updated 8 months ago
- Generalized Vehicle Control Unit for version 6 boards☆25Updated 11 months ago
- 7th generation GEVCU source code☆25Updated last week
- ☆10Updated last year
- Eagle schematics of inverter main board, sensor boards and gate drivers☆65Updated 2 years ago
- CAN bus analyzer software☆25Updated 2 years ago
- Generalized Electric Vehicle Control Unit☆117Updated 2 years ago
- Port of the Hubner Inverter to the TI C2000 architecture used by Tesla inverters.☆15Updated 2 years ago
- ☆21Updated 5 months ago
- Opensource controller for the Lexus GS450H Hybrid inverter and gearbox☆20Updated 3 years ago
- Opensource hardware stand alone controller for the Tesla Model 3 Charge Port ECU☆21Updated 3 years ago
- Bootloader project to update for example STM32F107 / GD32F107 chips☆12Updated 9 months ago
- CAN to USB adapter using Lawicel/Canhacker protocol.☆23Updated 5 years ago
- A tool to allow configuration and operating of openinverter systems for electric vehicles over a CAN connection☆17Updated 2 weeks ago
- Xvaser LL v2 firmware for CANtact ( CANable ) or any other similar boards.☆46Updated 3 years ago
- Empty Openinverter project to start your own☆15Updated last year
- Reverse Engineering of the Tesla 10Kw charger and development of an open source control board☆119Updated 4 years ago
- leaf spline revers engineering☆13Updated 4 years ago
- This is an Open Source Hardware USB to CAN-FD Interface☆64Updated 2 months ago
- Main firmware of the Huebner inverter project☆172Updated last month
- Fully Open CCS Charge Controller Interface with QCA7005 PLC modem☆78Updated 4 months ago
- CAN bus analyzing and simulation GUI tool for Windows.☆60Updated 2 months ago
- Hacking and reverse engineering of the VW Onboard AC chargers☆15Updated last year
- Partial Lawicel/SLCAN implementation at 1 Mb/s CAN speed and 460800 UART baud rate☆29Updated 6 years ago