damienmaguire / Tesla-Drive-UnitLinks
Open Source logic board for the Tesla Model S large rear drive unit. PCB Files in DesignSpark 8 format.
☆100Updated 5 years ago
Alternatives and similar repositories for Tesla-Drive-Unit
Users that are interested in Tesla-Drive-Unit are comparing it to the libraries listed below
Sorting:
- Open Source Logic board to control the Tesla Model S Front Drive Unit☆53Updated 2 months ago
- Reverse Engineering of the Tesla 10Kw charger and development of an open source control board☆129Updated 4 years ago
- Open source logic board to control the Toyota Prius Gen 3 Inverter☆51Updated 4 months ago
- Open Source logic board for the Tesla Model 3 rear drive unit. PCB Files in DesignSpark 8 format.☆81Updated last month
- Opensource hardware stand alone controller for the Tesla Model 3 Charge Port ECU☆22Updated 4 years ago
- Eagle schematics of inverter main board, sensor boards and gate drivers☆79Updated 3 years ago
- Generalized Electric Vehicle Control Unit☆117Updated 3 years ago
- Repurposes the openinverter main board as a buck or boost mode charger☆16Updated 2 years ago
- Reverse engineering of the Tesla Model 3 battery bms control☆69Updated 3 months ago
- My version of the Heubner open source electric vehicle motor inverter. All files in Designspark 8 format.☆12Updated 8 years ago
- Generalized Vehicle Reverse Engineering Tool - firmware for Arduino Due based boards☆107Updated 7 years ago
- Open Inverter - Alternative Web Interface☆34Updated 4 years ago
- Very hacky project that talks to the Nissan Leaf BMS (aka LBC) and to the VW CAN bus☆64Updated last week
- ARCHIVE: Lebowski controller IC 2.A1 source code and (short) explanation☆19Updated 5 years ago
- CAN Bus logger with SD card implemented using ChibiOS☆74Updated 6 years ago
- Redacted code for Rust-based Charge Port Controller☆11Updated 5 years ago
- OpenSource Control Unit for the Nissan Leaf Gen 1 and Gen 2 inverter☆62Updated 4 years ago
- microRusEfi board for rusEfi ECU☆85Updated 4 months ago
- Designs for the Macchina M2☆98Updated 5 years ago
- ☆44Updated 7 months ago
- Use openinverter hardware as an island (non-grid connected) inverter☆16Updated 5 years ago
- Main firmware of the Huebner inverter project☆181Updated last month
- ☆51Updated 6 years ago
- ☆33Updated 7 years ago
- Simple IGBT based controller for DC motors used in Electric Vehicles. Files in DesignSpark 8 format☆33Updated 6 years ago
- ☆177Updated 7 years ago
- Battery management system for up to 5 Li-ion cells based on TI bq76920☆43Updated 7 years ago
- ☆65Updated 4 years ago
- User documentation for rusEFI engine control unit☆48Updated this week
- Firmware for the CANalyze hardware.☆71Updated 2 years ago