celeron55 / prius3charger_buckLinks
Prius Gen 3 buck/boost converter charger controller - buck mode charging
☆13Updated 5 years ago
Alternatives and similar repositories for prius3charger_buck
Users that are interested in prius3charger_buck are comparing it to the libraries listed below
Sorting:
- Empty Openinverter project to start your own☆15Updated last year
- Eagle schematics of inverter main board, sensor boards and gate drivers☆67Updated 2 years ago
- ARCHIVE: Lebowski controller IC 2.A1 source code and (short) explanation☆18Updated 5 years ago
- OpenSource Control Unit for the Nissan Leaf Gen 1 and Gen 2 inverter☆61Updated 4 years ago
- ☆10Updated 2 years ago
- ESP32 Based Chademo implementation☆16Updated 9 months ago
- Main firmware of the Huebner inverter project☆173Updated 2 weeks ago
- Use openinverter hardware as an island (non-grid connected) inverter☆16Updated 4 years ago
- Very hacky project that talks to the Nissan Leaf BMS (aka LBC) and to the VW CAN bus☆60Updated 3 months ago
- Generalized Vehicle Control Unit for version 6 boards☆25Updated last year
- A Vehicle Control Unit for Electric Vehicle Conversion Projects based on an STM32F107. Software based on the Openinverter Project.☆166Updated this week
- Software for Damien Maguire's CHAdeMO controller☆21Updated 4 years ago
- Opensource controller for the Lexus GS450H Hybrid inverter and gearbox☆20Updated 4 years ago
- leaf spline revers engineering☆13Updated 4 years ago
- Repurposes the openinverter main board as a buck or boost mode charger☆16Updated last year
- Generalized Electric Vehicle Control Unit☆119Updated 2 years ago
- Port of the Hubner Inverter to the TI C2000 architecture used by Tesla inverters.☆16Updated 2 years ago
- This is an Open Source Hardware USB to CAN-FD Interface☆66Updated 4 months ago
- Collection of CAN logs from different electric vehicles☆33Updated 10 months ago
- Partial Lawicel/SLCAN implementation at 1 Mb/s CAN speed and 460800 UART baud rate☆29Updated 6 years ago
- Open Inverter - Alternative Web Interface☆32Updated 3 years ago
- A ESP32 based CAN interface for your webbrowser☆24Updated 4 years ago
- CAN Bus logger with SD card implemented using ChibiOS☆70Updated 6 years ago
- Generic modules that can be used in many projects☆30Updated 4 months ago
- reverse engineering of Hyundai Ioniq (classic, production 2018)☆19Updated this week
- Open source project that uses the CANable hardware from protofusion.org☆39Updated 5 years ago
- Reverse engineering of the on board charger (OBC) used in MG Electric Vehicles☆14Updated last year
- Open source logic board to control the Toyota Prius Gen 3 Inverter☆50Updated 3 years ago
- Hacking and reverse engineering of the VW Onboard AC chargers☆15Updated last year
- CAN to USB adapter using Lawicel/Canhacker protocol.☆22Updated 6 years ago