damienmaguire / Tesla-Front-Drive-UnitLinks
Open Source Logic board to control the Tesla Model S Front Drive Unit
☆52Updated 3 weeks ago
Alternatives and similar repositories for Tesla-Front-Drive-Unit
Users that are interested in Tesla-Front-Drive-Unit are comparing it to the libraries listed below
Sorting:
- Open Source logic board for the Tesla Model S large rear drive unit. PCB Files in DesignSpark 8 format.☆95Updated 5 years ago
- Reverse Engineering of the Tesla 10Kw charger and development of an open source control board☆127Updated 4 years ago
- Opensource hardware stand alone controller for the Tesla Model 3 Charge Port ECU☆22Updated 4 years ago
- Generalized Electric Vehicle Control Unit☆117Updated 3 years ago
- My version of the Heubner open source electric vehicle motor inverter. All files in Designspark 8 format.☆12Updated 8 years ago
- Eagle schematics of inverter main board, sensor boards and gate drivers☆75Updated 3 years ago
- Open Source logic board for the Tesla Model 3 rear drive unit. PCB Files in DesignSpark 8 format.☆72Updated this week
- Opensource controller for the Lexus GS450H Hybrid inverter and gearbox☆21Updated 4 years ago
- Reverse engineering of the Tesla Model 3 battery bms control☆65Updated 2 months ago
- Redacted code for Rust-based Charge Port Controller☆11Updated 5 years ago
- CAN Bus logger with SD card implemented using ChibiOS☆72Updated 6 years ago
- Very hacky project that talks to the Nissan Leaf BMS (aka LBC) and to the VW CAN bus☆61Updated 7 months ago
- Repurposes the openinverter main board as a buck or boost mode charger☆16Updated 2 years ago
- Open source logic board to control the Toyota Prius Gen 3 Inverter☆50Updated 3 months ago
- Open Inverter - Alternative Web Interface☆34Updated 3 years ago
- This is the software for running an AC INDUCTION OR PERMANENT MAGNET motor with field oriented control.☆52Updated 8 years ago
- OpenSource Control Unit for the Nissan Leaf Gen 1 and Gen 2 inverter☆61Updated 4 years ago
- A Vehicle Control Unit for Electric Vehicle Conversion Projects based on an STM32F107. Software based on the Openinverter Project.☆192Updated 2 weeks ago
- ☆51Updated 6 years ago
- Can Example for Arduino Core STM32☆11Updated 5 years ago
- ARCHIVE: Lebowski controller IC 2.A1 source code and (short) explanation☆19Updated 5 years ago
- ☆177Updated 7 years ago
- ☆10Updated 2 years ago
- Use openinverter hardware as an island (non-grid connected) inverter☆16Updated 4 years ago
- Generalized Vehicle Control Unit for version 6 boards☆25Updated last year
- Main firmware of the Huebner inverter project☆181Updated this week
- Empty Openinverter project to start your own☆15Updated last year
- ☆33Updated 6 years ago
- CAN_Interface for ESP32 (Cannelloni Protocol)☆59Updated 4 years ago
- ESP32 slcan compatible device☆103Updated 4 years ago