davefiddes / openinverter-can-toolLinks
A tool to allow configuration and operating of openinverter systems for electric vehicles over a CAN connection
☆18Updated this week
Alternatives and similar repositories for openinverter-can-tool
Users that are interested in openinverter-can-tool are comparing it to the libraries listed below
Sorting:
- Collection of CAN logs from different electric vehicles☆34Updated 11 months ago
- Reverse Engineering of the BMW SBox for use in ev conversion projects☆12Updated 2 years ago
- Fully Open CCS Charge Controller Interface with QCA7005 PLC modem☆82Updated 2 months ago
- Reverse engineering of the on board charger (OBC) used in MG Electric Vehicles☆18Updated 2 weeks ago
- CAN Reverse engineering tool for ESP32 based boards (specifically EVTV ESP32Due)☆303Updated 6 months ago
- A Vehicle Control Unit for Electric Vehicle Conversion Projects based on an STM32F107. Software based on the Openinverter Project.☆173Updated this week
- ESP32 Based Chademo implementation☆17Updated 10 months ago
- Hacking and reverse engineering of the VW Onboard AC chargers☆15Updated last year
- File converter from DBC to RealDash XML☆16Updated 3 months ago
- OpenSource Control Unit for the Nissan Leaf Gen 1 and Gen 2 inverter☆61Updated 4 years ago
- Bootloader project to update for example STM32F107 / GD32F107 chips☆17Updated last year
- LEAF CAN bus message decoding with proper database files☆197Updated 3 months ago
- STM32 with QCA7005 as CCS charge controller☆83Updated 3 weeks ago
- BMW CANbus gateway emulator & proxy☆20Updated 4 years ago
- ☆42Updated 3 years ago
- Volvo LIN bus reader☆93Updated 4 years ago
- Software for Damien Maguire's CHAdeMO controller☆22Updated 4 years ago
- Hardware - CAN enabled small input / output expansion board. Switch panels, steering wheel buttons/knobs, etc.☆40Updated 3 months ago
- leaf spline revers engineering☆14Updated 5 years ago
- Very hacky project that talks to the Nissan Leaf BMS (aka LBC) and to the VW CAN bus☆61Updated 3 months ago
- ☆17Updated 4 months ago
- Development of a control unit to permit Chademo 50kw DC Fast Charging on converted electric vehicles☆45Updated 4 years ago
- Opensource controller for the Lexus GS450H Hybrid inverter and gearbox☆21Updated 4 years ago
- ☆17Updated 3 years ago
- Reverse engineering the Volvo VIDA protocol and CAN network to gather diagnostic information not available via OBD2 on Volvo cars.☆111Updated 3 years ago
- J2534 drivers for various Macchina hardware☆98Updated 2 years ago
- Reverse engineering of the BMW i3 LIM (charge control) module for purposes of opensource CCS fast charging☆47Updated last year
- Tips and tricks on repairing the fragile ZE0 LEAF PTC heater☆11Updated 2 years ago
- Firmware - CAN enabled small input / output expansion board. Switch panels, steering wheel buttons/knobs, etc.☆13Updated 3 months ago
- An open source TCM for Daimlers 722.6 gearbox. Resource repository☆116Updated 9 months ago