jsphuebner / stm32-chargerLinks
Repurposes the openinverter main board as a buck or boost mode charger
☆16Updated 2 years ago
Alternatives and similar repositories for stm32-charger
Users that are interested in stm32-charger are comparing it to the libraries listed below
Sorting:
- ☆10Updated 2 years ago
- Empty Openinverter project to start your own☆15Updated last year
- Eagle schematics of inverter main board, sensor boards and gate drivers☆75Updated 3 years ago
- Generic modules that can be used in many projects☆29Updated 2 months ago
- Use openinverter hardware as an island (non-grid connected) inverter☆16Updated 4 years ago
- My version of the Heubner open source electric vehicle motor inverter. All files in Designspark 8 format.☆12Updated 8 years ago
- Open Inverter - Alternative Web Interface☆34Updated 3 years ago
- ARCHIVE: Lebowski controller IC 2.A1 source code and (short) explanation☆19Updated 5 years ago
- Yet another USB-CAN adapter.☆13Updated 3 years ago
- Prius Gen 3 buck/boost converter charger controller - buck mode charging☆14Updated 5 years ago
- Very hacky project that talks to the Nissan Leaf BMS (aka LBC) and to the VW CAN bus☆61Updated 7 months ago
- MPPT solar charge controller with dual USB ports☆70Updated 3 years ago
- Open Source logic board for the Tesla Model S large rear drive unit. PCB Files in DesignSpark 8 format.☆95Updated 5 years ago
- ☆51Updated 6 years ago
- A low-cost compact USB to CAN adapter.☆25Updated last year
- This is my MPPT project I am doing for a solar boat racing application called the DieBieMPPT☆16Updated 8 years ago
- Open source project that uses the CANable hardware from protofusion.org☆43Updated 3 months ago
- Open Source logic board for the Tesla Model 3 rear drive unit. PCB Files in DesignSpark 8 format.☆72Updated this week
- Probe Scope GUI☆13Updated 6 years ago
- Opensource controller for the Lexus GS450H Hybrid inverter and gearbox☆21Updated 4 years ago
- CAN Bus logger with SD card implemented using ChibiOS☆72Updated 6 years ago
- 2kVA power inverter - for google/ieee little box challenge☆15Updated 4 years ago
- MESC, Molony ESC, STM32F303 based FOC+BLDC ready, HALL, Encoder, Sensorless, single sides, 2 layer, ~90A @48V☆49Updated 4 years ago
- An open hardware platform for experimenting with DC-to-AC conversion, power and energy metering and grid tie inverters.☆72Updated last year
- Open Source Logic board to control the Tesla Model S Front Drive Unit☆52Updated 3 weeks ago
- Battery management system for up to 15 Li-ion cells using bq76940 or bq76930☆72Updated 3 years ago
- Firmware to support gs_usb on most STM32 devices☆51Updated 3 months ago
- Generalized Electric Vehicle Control Unit☆117Updated 3 years ago
- ☆67Updated 10 years ago
- Firmware of the MPPT Solar Charger Rev E (PIC18F47J53) with USB HID/MSD composite device☆24Updated 7 years ago