PCrnjak / 3D-printed-HexapodLinks
Code and STL files for small 18 servo hexapod.
☆32Updated last year
Alternatives and similar repositories for 3D-printed-Hexapod
Users that are interested in 3D-printed-Hexapod are comparing it to the libraries listed below
Sorting:
- ☆35Updated 3 years ago
- Sixi 2 Robot Arm☆34Updated 3 years ago
- ☆23Updated 5 years ago
- This repository contains the code, 3D-printable files and electronics to make my 3D Lidar.☆75Updated 2 years ago
- miniDog V2 CAD and Code☆64Updated 5 years ago
- Sixi Robot Arm☆23Updated 6 years ago
- ☆76Updated last year
- ☆203Updated last year
- ☆24Updated 3 years ago
- Library and UI to configure and control LewanSoul LX-16A servos☆66Updated 2 years ago
- G-code enabled firmware for Robot Arms☆33Updated 3 years ago
- ☆200Updated 4 years ago
- ☆58Updated 7 years ago
- This is the repo for the robot actuator v8 based on an ESP32 as the brains of each robot arm actuator.☆230Updated 4 years ago
- SCUTTLE™: Sensing, Connected, Utility Transport Taxi for Level Environments [An open-source Mobile Robot]☆84Updated last year
- A cycloidal reduction drive generator script for Fusion360☆116Updated 4 years ago
- STL files and instructions for uStepper Robot Arm Rev 4☆70Updated 4 years ago
- Quadruped Robot for capstone project☆54Updated 3 years ago
- Simple Arduino library to operate LX-16A, LX-224 and LX-15D serial servos☆64Updated 2 years ago
- Dexter Development Environment☆46Updated 7 months ago
- This repository is for my 3D printed delta robot controlled by an Arduino Nano.☆51Updated 5 years ago
- All the things for RobotX☆128Updated 7 years ago
- S_Drive is small bldc driver based on L6234 Three phase motor driver.☆43Updated last year
- Hexy the Open-Source, Low-Cost Hexapod☆121Updated 6 years ago
- ☆34Updated 6 months ago
- 6DOF Industrial Robot, vintage style☆150Updated 8 years ago
- Parallel mechanism for wrist in robotics hand☆55Updated 6 years ago
- Software to drive a 3D printed robot with a SlushEngine or other motor controller driver☆28Updated 8 years ago
- DIY project of a quadruped robot as a exercise for programming.☆22Updated 5 years ago
- uStepper Robot Arm STL files and instruction Revision 3☆94Updated 7 years ago