LibreSolar / solarduino-li-ionLinks
Solar charge controller with integrated 12 V Li-Ion BMS
☆15Updated 6 years ago
Alternatives and similar repositories for solarduino-li-ion
Users that are interested in solarduino-li-ion are comparing it to the libraries listed below
Sorting:
- 12A MPPT solar charge controller based on Arduino☆12Updated 9 years ago
- Maximum power point tracking solar charge controller☆17Updated 8 years ago
- Solar/Wind MPPT charge controller for DIN rail mounting☆16Updated 5 years ago
- Open Source MPPT for Lithium Batteries. Based on TI controller☆16Updated 8 years ago
- Solar MPPT Charger Implemented with BQ24650 MPS430 MCU☆19Updated 8 years ago
- ☆17Updated 9 years ago
- Master code for slave devices☆19Updated 5 years ago
- Arduino software for an electronically controlled load, based on a STM32 microcontroller☆21Updated 4 years ago
- ☆23Updated 6 years ago
- Arduino-compatible library for battery management system based on Texas Instruments bq769x0 analog frontend (bq76920, bq76930 and bq76940…☆46Updated 4 months ago
- Open source Maximum Power Point Tracking (MPPT) and inverter hardware/software for photovoltaic projects.☆45Updated 5 years ago
- WIZnet Serial to Ethernet(S2E) module based on W7500 chip, WIZ107/108SR S2E compatible device☆19Updated 6 months ago
- 5uH DC LISN (-10 dB attenuation)☆18Updated 6 years ago
- CAN bus gateway over USB☆21Updated 3 years ago
- Battery management system for up to 5 Li-ion cells based on TI bq76920☆40Updated 6 years ago
- Arduino port for STM8S/STM8A 8-bit MCUs☆12Updated 8 years ago
- This is a demo program. STM32F1 development board (OPEN103Z-B) monitors current and voltage ratings through INA219 IC and displays it on …☆12Updated 10 years ago
- Arduino Current Transformer Library☆17Updated 5 years ago
- Here is an universal 1S to 4S BMS charger/tester either for Li-ion or LifePo4 cells buit arround an Arduino Uno☆15Updated 4 years ago
- Nscreen32 is a ESP32 display board, it included ESP32-WROVER-IE(16M Flash + 8M PSRAM), a 480x320 4 inch TFT display, a GT911 touch scree…☆18Updated 2 years ago
- Arduino-based battery internal resistance meter☆45Updated 8 years ago
- A library for handling communication through the Semtech SX1276/7/8/9 devices.☆8Updated 4 years ago
- ☆11Updated 7 years ago
- OneWire library custom engineered for JLD505 boards with DS2480B chips☆10Updated 10 years ago
- Single-Cell Li-Ion, LiPo and LiFePO4 Battery Capacity Tester☆25Updated 2 years ago
- 2kVA power inverter - for google/ieee little box challenge☆14Updated 3 years ago
- This is my MPPT project I am doing for a solar boat racing application called the DieBieMPPT☆14Updated 7 years ago
- ☆17Updated 4 years ago
- Dual motor serial controller - ATmega 328 MCU with VNH5019 motor drivers☆16Updated 8 months ago
- Firmware for CAN/UART to WiFi/BLE gateway using ESP32☆27Updated 3 years ago