damienmaguire / Tesla-Model-3-Drive-UnitLinks
Open Source logic board for the Tesla Model 3 rear drive unit. PCB Files in DesignSpark 8 format.
☆81Updated last month
Alternatives and similar repositories for Tesla-Model-3-Drive-Unit
Users that are interested in Tesla-Model-3-Drive-Unit are comparing it to the libraries listed below
Sorting:
- Eagle schematics of inverter main board, sensor boards and gate drivers☆78Updated 3 years ago
- Open Source logic board for the Tesla Model S large rear drive unit. PCB Files in DesignSpark 8 format.☆99Updated 5 years ago
- Reverse Engineering of the Tesla 10Kw charger and development of an open source control board☆129Updated 4 years ago
- Open Source Logic board to control the Tesla Model S Front Drive Unit☆53Updated 2 months ago
- CAN Bus logger with SD card implemented using ChibiOS☆73Updated 6 years ago
- Firmware to support gs_usb on most STM32 devices☆53Updated 4 months ago
- ☆20Updated 9 months ago
- ☆10Updated 2 years ago
- CAN (Dual) bus Arduino library for stm32F042, stm32F103, stm32F105, stm32F107, stm32L4, stm32F4☆29Updated 2 years ago
- ☆51Updated 6 years ago
- This is an Open Source Hardware USB to CAN-FD Interface☆75Updated last month
- Main firmware of the Huebner inverter project☆181Updated last month
- ☆30Updated 2 months ago
- ☆72Updated 3 years ago
- Empty Openinverter project to start your own☆15Updated last week
- Low cost USB to CAN-FD (Controller Area Network - Flexible Data rate) interface.☆19Updated 2 years ago
- Reverse engineering of the Tesla Model 3 battery bms control☆67Updated 3 months ago
- Open source logic board to control the Toyota Prius Gen 3 Inverter☆51Updated 4 months ago
- Entree is a USB-C CAN interface with USB-PD - gets the CAN party started!☆85Updated last year
- Opensource controller for the Lexus GS450H Hybrid inverter and gearbox☆21Updated 4 years ago
- User documentation for rusEFI engine control unit☆47Updated last week
- ESP32 slcan compatible device☆103Updated last week
- Repurposes the openinverter main board as a buck or boost mode charger☆16Updated 2 years ago
- Very hacky project that talks to the Nissan Leaf BMS (aka LBC) and to the VW CAN bus☆64Updated 9 months ago
- This is project SuperCAN. An open source USB to CAN-FD protocol.☆91Updated 5 months ago
- Firmware for the CANtact Pro☆49Updated 2 years ago
- Port of the Hubner Inverter to the TI C2000 architecture used by Tesla inverters.☆19Updated 2 years ago
- Generalized Electric Vehicle Control Unit☆117Updated 3 years ago
- ☆121Updated last year
- ARCHIVE: Lebowski controller IC 2.A1 source code and (short) explanation☆19Updated 5 years ago