LuSeKa / HoverBot
Self-balancing robot using hoverboard hub motors
☆108Updated 2 years ago
Related projects ⓘ
Alternatives and complementary repositories for HoverBot
- Hardware and Software for an Open Source Robotic Leg☆78Updated last year
- ROS driver for the ODrive motor drive☆72Updated 2 years ago
- ☆71Updated 4 years ago
- MORPH : Modular Open Robotics Platform for Hackers☆44Updated 5 years ago
- Hardware and Firmware of the Solo Quadruped Master Board☆120Updated last month
- ROS hardware driver for UART-controlled hoverboard☆98Updated 5 months ago
- A simple C++ SDK for interacting with ODrive☆27Updated last year
- ROS project for Robaka - mobile ROS testbed☆72Updated 2 years ago
- Arduino Kinematics library for differential drive(2WD, 4WD) and mecanum drive robots.☆65Updated 5 years ago
- Dual brushless motor ESC in #M5Stack module format☆28Updated 2 years ago
- Open-source drive for brushless motors, following the open dynamic robot initiative☆82Updated last week
- ROS hexapod robot on BeagleBone Black☆97Updated 6 years ago
- SpryDrive is an affordable actuator based on the quasi-direct drive (QDD) scheme. It is composed of a brushless outrunner motor, a low-co…☆36Updated 3 years ago
- BOM, Circuit and PCB Gerber of OpenCR☆110Updated 4 years ago
- ☆32Updated 2 years ago
- ☆26Updated 2 years ago
- Library and UI to configure and control LewanSoul LX-16A servos☆64Updated last year
- Robotic quadruped☆43Updated 6 years ago
- ☆41Updated last month
- ROS serial for ESP8266 over WiFi☆126Updated 4 years ago
- ☆67Updated 9 months ago
- ☆21Updated 4 years ago
- The Janus Controller is a Brushless motor driver with an on-board magnetic encoder, a three-phase MOSFET driver, three MOSFET half-bridge…☆116Updated 3 years ago
- Analytical trapezoidal motion generator in Arduino and Matlab☆47Updated 2 years ago
- Classes for control of a differential drive robot using PID control of DC motors☆44Updated 7 years ago
- S_Drive is small bldc driver based on L6234 Three phase motor driver.☆41Updated 8 months ago
- ☆48Updated 6 years ago
- Set up ROS, OpenCV and other ROSbots modules for your ROBbots robot☆98Updated 5 years ago
- Software to drive a 3D printed robot with a SlushEngine or other motor controller driver☆28Updated 7 years ago
- OpenTorque Actuator: A powerful, compliant actuator for legged robotics.☆308Updated 5 years ago