makerbase-mks / MKS-DUALFOCLinks
☆22Updated 2 years ago
Alternatives and similar repositories for MKS-DUALFOC
Users that are interested in MKS-DUALFOC are comparing it to the libraries listed below
Sorting:
- ☆14Updated last year
- ☆53Updated last year
- ☆85Updated 4 years ago
- ☆44Updated 7 months ago
- S_Drive is small bldc driver based on L6234 Three phase motor driver.☆43Updated last year
- A cycloidal reduction drive generator script for Fusion360☆114Updated 4 years ago
- ☆26Updated 3 years ago
- WIP SimpleFoc running Dynamixel Protocol☆13Updated 3 years ago
- The Janus Controller is a Brushless motor driver with an on-board magnetic encoder, a three-phase MOSFET driver, three MOSFET half-bridge…☆126Updated 4 years ago
- ☆21Updated 5 years ago
- Makerbase MKS SERVO57D NEMA23 closed loop stepper motor Driver FOC quiet and efficient RS485 / CAN☆56Updated 8 months ago
- With Field Oriented Control (FOC)☆49Updated 2 years ago
- Currently running saddle sinusoidal control. FOC requires 3 phase current feedback and the CLARKE & PARK transforms.☆40Updated 4 years ago
- B-G431B-ESC Brushless Servo Controller☆68Updated 3 years ago
- One forth scale model of the KUKA KR350 model 3D printed and Arduino controlled.☆47Updated 3 years ago
- A cycloid gear graphical calculator to design cycloidal drives.☆119Updated 3 years ago
- Arduino TWAI library for Xiaomi CyberGear☆38Updated 9 months ago
- CHEAP LAWNMOWER ROBOT USING A HOVERBOARD (Hacked Firmware)☆24Updated 4 years ago
- The library comes with AS5600. Through this library, we can realize read the angles 、get magnetic from a magnet underneath the sensor.☆113Updated 5 months ago
- ☆24Updated 4 years ago
- SpryDrive is an affordable actuator based on the quasi-direct drive (QDD) scheme. It is composed of a brushless outrunner motor, a low-co…☆39Updated 4 years ago
- Open source 3D printed Robotic Actuator☆77Updated 2 years ago
- SCS/SMS servo library for Arduino [Not mine]☆12Updated 3 years ago
- Hardware and Software for an Open Source Robotic Leg☆80Updated last year
- This software will run the ADC variant with added PID closed loop control of the motors.☆28Updated 4 years ago
- Self-balancing robot using hoverboard hub motors☆22Updated 3 years ago
- This repo contains the CAN bus protocol for VESC that can be used with arduino and the MCP2515 driver library☆38Updated 2 months ago
- ☆58Updated 7 years ago
- Spectral Micro BLDC controller☆71Updated last month
- ☆54Updated last year