custom-build-robots / raspberry-pi-rc-car-controller
This program is used to control a RC car with a Raspberry Pi and a PCA9685 servo controller.
☆12Updated 7 years ago
Alternatives and similar repositories for raspberry-pi-rc-car-controller:
Users that are interested in raspberry-pi-rc-car-controller are comparing it to the libraries listed below
- CAD files for the Mantis Rover Project - 3D printed mecanum wheel rover.☆16Updated 5 years ago
- Arduino Library to control R/C ESC's☆63Updated last year
- ☆40Updated 7 years ago
- Software for controlling and analysing T-Bots (Balancing robots)☆31Updated 11 months ago
- ☆33Updated 3 years ago
- Source code of project rover tracks: https://www.thingiverse.com/thing:3112734☆11Updated 6 years ago
- ☆57Updated 4 years ago
- Detailed introduction of TFmini-Plus☆16Updated 5 years ago
- BBC micro:bit Power Board☆13Updated 5 years ago
- Based on the miniKame, modifications to the body of the robot to allow more space, included a ultrasonic sensor. ESP8266 based quadruped …☆28Updated 9 years ago
- Kame is a bigger version of MiniKame. Controlled by a Raspberry PI 2 and Python.☆13Updated 9 years ago
- 3D printed self balancing robot using and ESP32 for the brains, MPU6050 for gyros & accelerometres and DRV8825 to drive the 2 servo motor…☆81Updated 7 years ago
- NE Five ROS Metapackage☆21Updated 5 months ago
- Code for MobBob, The Smart Phone Controlled Desktop Robot☆35Updated 8 years ago
- ☆45Updated 7 years ago
- Micro Robot Arm with ESP32 and 28BY-48 12V steppers☆82Updated 5 years ago
- A senior capstone project by a Computer Science team at Miami University☆12Updated 7 years ago
- ☆72Updated last year
- B-ROBOT Arduino self balancing robot from JJROBOTS.com☆110Updated 4 years ago
- ☆37Updated 5 years ago
- ☆41Updated 6 years ago
- Use Hoverboards to add motor drives to assistive devices.☆18Updated 3 years ago
- 3D printed, low cost transport vehicle controlled over mobile internet and programed in Python☆82Updated 2 years ago
- A small wheeled or tracked robot running on Circuit Python☆18Updated 3 years ago
- A 3D printed balancing robot☆73Updated 7 years ago
- GUI for Thor developed using PyQt5☆24Updated 3 years ago
- STL files and instructions for uStepper Robot Arm Rev 4☆67Updated 4 years ago
- Hacking of the Neato XV-11 lidar☆84Updated 4 years ago
- ☆48Updated 6 years ago
- G-code enabled firmware for Robot Arms☆33Updated 3 years ago