tedyapo / sampling-scope-WIPLinks
Work towards an open-source multi-GHz sampling oscilloscope design
☆36Updated 6 years ago
Alternatives and similar repositories for sampling-scope-WIP
Users that are interested in sampling-scope-WIP are comparing it to the libraries listed below
Sorting:
- Prototype time domain reflectometer/sampling oscilloscope☆53Updated 6 years ago
- It started as some general experiments with RF stuff and gradually evolved into a (severely limited) spectrum analyzer.☆48Updated 6 years ago
- Design files for sdr5 prototype (Zynq + AD9363)☆108Updated 6 years ago
- ICE40 8K FPGA / STM32F4 development system☆62Updated 8 years ago
- experimental open hardware e-field and h-field probes and LISN☆27Updated 3 years ago
- a simple and cheap vector network analyzer, including support software☆161Updated 5 years ago
- A tiny 1.3 GHz FET Probe☆34Updated 3 years ago
- ECP5 FPGA in an "S7 Mini" form factor☆89Updated 4 years ago
- WCH CH569 SerDes Reverse Engineering☆30Updated 3 years ago
- Test code to talk from STM32 MCU over FSMC to SDRAM on ICE40 FPGA☆29Updated 9 years ago
- 1MHz to 6GHz USB based vector network analyzer☆147Updated 5 years ago
- Source code of MIPI DSI Bridge Published on https://www.circuitvalley.com☆114Updated last year
- Jim Williams Pulse Generator for oscilloscope rise time measurements☆29Updated 4 years ago
- ☆37Updated 5 years ago
- Digital FM Radio Receiver for FPGA☆63Updated 10 years ago
- KiCad PCB project of Logic Analyzer☆44Updated 5 years ago
- A 5$ Xilinx ZYNQ development board.☆27Updated 2 years ago
- 5MHz to 2.1GHz RF Synthesizer with modulation capability☆57Updated 2 years ago
- FPGA-Based DIY Function Generator☆59Updated 5 years ago
- ESP8266 Xilinx Virtual Cable - wifi JTAG☆40Updated 4 years ago
- Vivado and PetaLinux projects for Zynq EBAZ4205 Board☆87Updated 4 years ago
- ESP8266 powered Xilinx Virtual Cable - Xilinx WiFi JTAG!☆30Updated 4 years ago
- Time domain reflectometer. Includes Hardware, firmware and GUI in Octave. Also a diploma thesis.☆23Updated 4 years ago
- 4 port eCal module☆108Updated 5 months ago
- Port of https://github.com/eleqian/WiDSO/tree/master/MCU/USB-Blaster to GCC and "traditional" STM32F103C8T6 Bluepill board.☆43Updated 6 years ago
- Low-cost ECP5 FPGA development board☆80Updated 5 years ago
- USB3 super speed development board useful as FPGA expansion based on WCH-Tech CH569☆27Updated 3 years ago
- A fully-integrated FT8 protocol receiver on 130nm CMOS☆61Updated 3 years ago
- Altium Designer libraries for ANSI/VITA 57 FPGA Mezzanine Card (FMC) Standard☆45Updated 4 years ago
- ULPI Link Wrapper (USB Phy Interface)☆34Updated 5 years ago