Alternatives and similar repositories for esp32-xbee:

Users that are interested in esp32-xbee are comparing it to the libraries listed below

• Coffeetrac / AG_NTRIP_ESP
  AG Rooftop controller with NTRIP client and IMU (ESP32 Controller)
  ☆38Updated 6 years ago
• GLAY-AK2 / NTRIP-client-for-Arduino
  ☆53Updated 5 years ago
• jangleboom / RTKBaseStation
  Real time kinematics base station (ESP32 + ZED-F9P)
  ☆32Updated 2 years ago
• GNSSOEM / ELT_RTKBase
  Raspbian compatible RtkBase software for Unicore UM98x, Bynav M2x and Septentrio Mosaic X5
  ☆41Updated this week
• incarvr6 / esp32-ntrip-DUO
  ESP32 NTRIP Interface
  ☆45Updated last month
• mtz8302 / AOG_GPS_ESP32
  DUAL or SINGLE GPS bridge between AgOpenGPS an GPS receiver. Works with 2 UBlox to calculate heading+roll. Corrects and filters. ESP32 + …
  ☆37Updated last year
• sparkfun / SparkFun_RTK_Firmware
  Centimeter precision GPS/GNSS using L1/L2 signals broadcast over Bluetooth SPP (using the ESP32) in an easy to use enclosure.
  ☆91Updated last month
• lansalot / FreeRTK
  How to set up your own RTK base station
  ☆37Updated last year
• sparkfun / SparkFun_Ublox_Arduino_Library
  Library to control UBX binary protocol and NMEA over I2C on Ublox GPS modules
  ☆145Updated 4 years ago
• doppelgrau / esp32-f9p-io-board
  An IO-PCB (two motor-driver/H-bridge, CAN, RS232, ADS1115, relay, ethernet, ardusimple f9p compatible connector) with an ESP32 for 12V po…
  ☆37Updated 5 years ago
• PaulZC / ZED-F9P_FeatherWing_USB
  A GNSS FeatherWing incorporating the u-blox ZED-F9P. Provides access to the ZED-F9P's USB, I2C, UART1 and UART2 ports.
  ☆23Updated 8 months ago
• sparkfun / SparkFun_u-blox_GNSS_Arduino_Library
  An Arduino library which allows you to communicate seamlessly with the full range of u-blox GNSS modules
  ☆239Updated last month
• Coffeetrac / Autosteer_ESP
  Advanced Autosteer Sketch for ESP32 - WiFi Version
  ☆38Updated 6 years ago
• sparkfun / SparkFun_RTK_Facet
  The hardware and enclosure for the popular centimeter level RTK Facet GNSS receiver with built in display.
  ☆20Updated 5 months ago
• eringerli / RpiNtripBase
  ☆50Updated 4 years ago
• PaulZC / F9P_RAWX_Logger
  A guide on how to assemble a GNSS PPK RAWX Logger from an Adafruit Feather M0 Adalogger and a SparkFun GPS-RTK2 Board which incorporates …
  ☆33Updated 5 years ago
• CentipedeRTK / pi-gen_RTKbase
  fork for RTKbase https://github.com/Stefal/rtkbase. Tool used to create the raspberrypi.org Raspbian images
  ☆19Updated 5 months ago
• slgrobotics / Esp32_RTK_BaseStation
  Esp32 RTK BaseStation - sends u-Blox ZED-F9P RTCM correction data to rtk2go.com NTRIP caster
  ☆30Updated 2 years ago
• pjalocha / esp32-ogn-tracker
  OGN Tracker implementation on ESP32 devices
  ☆59Updated last year
• wellenvogel / esp32-nmea2000
  nmea2000 gateway with ESP32
  ☆74Updated 2 weeks ago
• eringerli / esp32-aog
  Software to controll the tractor from AgOpenGPS
  ☆28Updated 2 years ago
• AK-Homberger / M5Stack-NMEA-2000-Display-CAN-BUS
  This repository shows how to use the M5Stack as NMEA 2000 Display and WiFi Gateway.
  ☆38Updated 3 years ago
• jacobjhansen / RTCM-Pi
  GNSS Base Station based on Raspberry Pi 4B
  ☆40Updated last year
• bolderflight / ublox
  Arduino and CMake library for communicating with uBlox GPS receivers.
  ☆105Updated 11 months ago
• hatlabs / SH-ESP32-hardware
  Sailor Hat for ESP32 hardware
  ☆45Updated 4 months ago
• eringerli / QtOpenGuidance
  ☆23Updated 5 months ago
• hatlabs / SH-ESP32-nmea2000-gateway
  An Actisense NGT-1 compatible NMEA 2000 USB gateway for the SH-ESP32
  ☆31Updated last year
• hcwinsemius / RTK_GNSS
  Manual for RTK GNSS with low cost u-blox ZED-F9P receivers rover-base setup
  ☆57Updated last year
• kriswiner / CMWX1ZZABZ
  Collection of sketches using the Arduino core for Murata's CMWX1ZZABZ (STM32L082 and SX1276)
  ☆99Updated last year
• mazgch / hpg
  This project demonstrates a full RTK solution with built in correction services.
  ☆94Updated 2 months ago