GNSSOEM / ELT_RTKBaseLinks
Raspbian compatible RtkBase software for Unicore UM98x, Bynav M2x and Septentrio Mosaic X5
☆59Updated last week
Alternatives and similar repositories for ELT_RTKBase
Users that are interested in ELT_RTKBase are comparing it to the libraries listed below
Sorting:
- Script for transferring section control and speed data between AgOpenGPS and Bogballe spreaders☆16Updated 6 months ago
- ☆50Updated 4 years ago
- ☆16Updated last month
- Autosteering and RTK-GNSS units for AgOpenGPS / QtOpenGuidance☆64Updated 2 years ago
- fork for RTKbase https://github.com/Stefal/rtkbase. Tool used to create the raspberrypi.org Raspbian images☆23Updated last year
- Docker Container that Takes in USB or TCP Based Serial GPS Receiver Output and Forwards the Data to Either Onocoy or RTKDirect or Both.☆17Updated 7 months ago
- AgOpenGPS rate control.☆38Updated this week
- ESP32 XBee UART Interface☆112Updated 2 years ago
- Your own GNSS base station for RTK localization with a Web GUI☆660Updated last month
- DUAL or SINGLE GPS bridge between AgOpenGPS an GPS receiver. Works with 2 UBlox to calculate heading+roll. Corrects and filters. ESP32 + …☆41Updated 2 years ago
- The Millipede NTRIP/RTK caster☆30Updated this week
- Docker file and instructions to build and run the BKG NTRIP caster☆118Updated last year
- Wireless RTK Grade Program☆15Updated 11 months ago
- How to set up your own RTK base station☆42Updated last year
- UM982 specific AgOpenGPS Firmware☆13Updated 4 months ago
- The datasheets and documentation for the centimeter level RTK Torch GNSS receiver with built in tilt compensation.☆11Updated 8 months ago
- ☆15Updated 3 months ago
- Centimeter precision GPS/GNSS using L1/L2/L5 signals broadcast over Bluetooth, WiFi, and Ethernet.☆40Updated this week
- ESP32 NTRIP Interface☆66Updated 8 months ago
- 3D grade control☆12Updated 4 months ago
- Complete section control solution using Ag Open GPS software and arduino controler. Could be adapted on old machineries, such as sprayer,…☆14Updated last month
- Manual for RTK GNSS with low cost u-blox ZED-F9P receivers rover-base setup☆62Updated last year
- GPS and Steer Boards☆51Updated 3 months ago
- Software to controll the tractor from AgOpenGPS☆32Updated 2 years ago
- A tool to configure the hardware components for AgOpenGPS☆18Updated last week
- Single-Frequency RTK-GNSS Rover/Base Station based on RTKLIB☆95Updated 6 years ago
- ☆11Updated last month
- A Qt C++ port of BrianT's AgOpenGPS☆46Updated 7 months ago
- A GNSS FeatherWing incorporating the u-blox ZED-F9P. Provides access to the ZED-F9P's USB, I2C, UART1 and UART2 ports.☆22Updated last year
- GNSS Base Station based on Raspberry Pi 4B☆49Updated 2 years ago