lansalot / FreeRTKLinks
How to set up your own RTK base station
☆44Updated 2 years ago
Alternatives and similar repositories for FreeRTK
Users that are interested in FreeRTK are comparing it to the libraries listed below
Sorting:
- Autosteering and RTK-GNSS units for AgOpenGPS / QtOpenGuidance☆67Updated 3 years ago
- fork for RTKbase https://github.com/Stefal/rtkbase. Tool used to create the raspberrypi.org Raspbian images☆24Updated last year
- Script for transferring section control and speed data between AgOpenGPS and Bogballe spreaders☆17Updated 9 months ago
- DUAL or SINGLE GPS bridge between AgOpenGPS an GPS receiver. Works with 2 UBlox to calculate heading+roll. Corrects and filters. ESP32 + …☆42Updated 2 years ago
- Raspbian compatible RtkBase software for Unicore UM98x, Bynav M2x and Septentrio Mosaic X5☆62Updated this week
- Software to controll the tractor from AgOpenGPS☆34Updated 3 years ago
- Wireless RTK Grade Program☆16Updated 2 months ago
- ☆15Updated 6 months ago
- ☆51Updated 5 years ago
- AgOpenGPS rate control.☆40Updated this week
- Useful code to work with Ardusimple simpleRTK2B application board☆37Updated 4 years ago
- ☆17Updated 2 months ago
- AG Rooftop controller with NTRIP client and IMU (ESP32 Controller)☆42Updated 6 years ago
- GPS and Steer Boards☆57Updated 6 months ago
- ESP32 XBee UART Interface☆114Updated 3 years ago
- Advanced Autosteer Sketch for ESP32 - WiFi Version☆38Updated 6 years ago
- A guide on how to assemble a GNSS PPK RAWX Logger from an Adafruit Feather M0 Adalogger and a SparkFun GPS-RTK2 Board which incorporates …☆34Updated 6 years ago
- Complete section control solution using Ag Open GPS software and arduino controler. Could be adapted on old machineries, such as sprayer,…☆14Updated 4 months ago
- ESP32 NTRIP Interface☆70Updated 11 months ago
- GNSS Base Station based on Raspberry Pi 4B☆50Updated 2 years ago
- A GNSS FeatherWing incorporating the u-blox ZED-F9P. Provides access to the ZED-F9P's USB, I2C, UART1 and UART2 ports.☆22Updated last year
- Manual for RTK GNSS with low cost u-blox ZED-F9P receivers rover-base setup☆61Updated last year
- AgOpenGPS using Teensy4.1 and CANBUS AutoSteer Ready Tractors☆33Updated 11 months ago
- A tool to configure the hardware components for AgOpenGPS☆20Updated this week
- Real time kinematics base station (ESP32 + ZED-F9P)☆42Updated 3 years ago
- Esp32 RTK BaseStation - sends u-Blox ZED-F9P RTCM correction data to rtk2go.com NTRIP caster☆32Updated 3 years ago
- 3D grade control☆14Updated 2 months ago
- A Qt C++ port of BrianT's AgOpenGPS☆48Updated this week
- implementation of an ISOBUS-VT on ESP32 device "M5Stack"☆34Updated last year
- UM982 specific AgOpenGPS Firmware☆14Updated 7 months ago