CentipedeRTK / pi-gen_RTKbase
fork for RTKbase https://github.com/Stefal/rtkbase. Tool used to create the raspberrypi.org Raspbian images
☆21Updated 7 months ago
Alternatives and similar repositories for pi-gen_RTKbase:
Users that are interested in pi-gen_RTKbase are comparing it to the libraries listed below
- UM982 specific AgOpenGPS Firmware☆13Updated 6 months ago
- DUAL or SINGLE GPS bridge between AgOpenGPS an GPS receiver. Works with 2 UBlox to calculate heading+roll. Corrects and filters. ESP32 + …☆41Updated last year
- A GNSS FeatherWing incorporating the u-blox ZED-F9P. Provides access to the ZED-F9P's USB, I2C, UART1 and UART2 ports.☆23Updated 9 months ago
- Script for transferring section control and speed data between AgOpenGPS and Bogballe spreaders☆16Updated 3 weeks ago
- AgOpenGPS V5 + V4 autosteer code for ESP32☆10Updated 2 years ago
- Software to controll the tractor from AgOpenGPS☆28Updated 2 years ago
- Useful code to work with Ardusimple simpleRTK2B application board☆37Updated 3 years ago
- Real time kinematics base station (ESP32 + ZED-F9P)☆35Updated 2 years ago
- AG Rooftop controller with NTRIP client and IMU (ESP32 Controller)☆39Updated 6 years ago
- How to set up your own RTK base station☆41Updated last year
- The hardware and enclosure for the popular centimeter level RTK Facet GNSS receiver with built in display.☆20Updated 7 months ago
- ☆50Updated 4 years ago
- AgOpenGPS rate control.☆35Updated this week
- Section Control for AgOpenGPS for ESP32 supporting 16 sections and switches to remote AOG☆13Updated last year
- Manual for RTK GNSS with low cost u-blox ZED-F9P receivers rover-base setup☆60Updated last year
- A raw data logger based on the u-blox ZED-F9P GNSS receiver intended for use with Precise Point Positioning (PPP) and Post-Processed Kine…☆11Updated 4 years ago
- ☆9Updated last week
- 🛰️ 📡 Broadcasting the RTCM3 correction from the nearest RTK base 📍☆19Updated last year
- Raspbian compatible RtkBase software for Unicore UM98x, Bynav M2x and Septentrio Mosaic X5☆42Updated last week
- ☆13Updated 3 weeks ago
- A guide on how to assemble a GNSS PPK RAWX Logger from an Adafruit Feather M0 Adalogger and a SparkFun GPS-RTK2 Board which incorporates …☆34Updated 5 years ago
- Centimeter precision GPS/GNSS using L1/L2/L5 signals broadcast over Bluetooth, WiFi, and Ethernet.☆31Updated this week
- Advanced Autosteer Sketch for ESP32 - WiFi Version☆38Updated 6 years ago
- Another containerised ntripcaster!☆20Updated 6 months ago
- An IO-PCB (two motor-driver/H-bridge, CAN, RS232, ADS1115, relay, ethernet, ardusimple f9p compatible connector) with an ESP32 for 12V po…☆38Updated 5 years ago
- GPS and Steer Boards☆46Updated last week
- Esp32 RTK BaseStation - sends u-Blox ZED-F9P RTCM correction data to rtk2go.com NTRIP caster☆31Updated 2 years ago
- GNSS Base Station based on Raspberry Pi 4B☆43Updated last year
- Simple utility to enable internal RTK mode in Ublox ZED-F9P GPS receiver with RTKLIB-compatible output☆14Updated 5 years ago
- AgOpenGPS using Teensy4.1 and CANBUS AutoSteer Ready Tractors☆30Updated 2 months ago