AnttiLukats / OZOM-Model-ALinks
Open Hardware Zynq System on Module
☆30Updated 10 years ago
Alternatives and similar repositories for OZOM-Model-A
Users that are interested in OZOM-Model-A are comparing it to the libraries listed below
Sorting:
- Open Source ZYNQ Board☆31Updated 10 years ago
- Yet Another XC7Z010 Board☆17Updated 3 years ago
- 4-Layer XC7Z010 DDR3 Layout☆18Updated 4 years ago
- Xilinx Virtual Cable Daemon☆20Updated 6 years ago
- Test code to talk from STM32 MCU over FSMC to SDRAM on ICE40 FPGA☆29Updated 8 years ago
- ☆21Updated 10 years ago
- Design to connect Lattice Ultraplus FPGA to OV7670 Camera Module☆21Updated 7 years ago
- KiCad PCB project of Logic Analyzer☆43Updated 4 years ago
- USBTMC DAC firmware for the stm32f4 discovery board☆25Updated 11 years ago
- FPGA development platform for high-performance RF and digital design☆32Updated 10 years ago
- Xilinx 7-series FTDI-FPGA interface through JTAG with 125 us roundtrip latency☆19Updated 6 years ago
- FPGArduino source☆70Updated 6 years ago
- Altera Cyclone IV FPGA project for the PCIe LimeSDR board☆41Updated 3 years ago
- Open Hardware carrier board supporting modules with Zynq 7000 All Programmable SoC devices.☆61Updated 2 years ago
- PulseRain FP51 MCU, with peripherals☆17Updated 7 years ago
- My self-designed ZYNQ-7010 4-layer developement board.☆33Updated 4 years ago
- Wi-Fi enabled XVC programmer/debugger based on ESP8266☆12Updated 10 years ago
- Zynq-Feather brings the power of a Xilinx Zynq SoC (ARM + FPGA) into the compact Adafruit Feather form factor — enabling modular, high-pe…☆49Updated 4 years ago
- WCH CH569 SerDes Reverse Engineering☆27Updated 3 years ago
- USB3 super speed development board useful as FPGA expansion based on WCH-Tech CH569☆27Updated 2 years ago
- Digital FM Radio Receiver for FPGA☆63Updated 9 years ago
- Simple but Small Frame Grabber☆38Updated 4 years ago
- DVI to LVDS Verilog converter☆24Updated 9 years ago
- ESP8266 Xilinx Virtual Cable - wifi JTAG☆40Updated 4 years ago
- Adapter board exposing SATA M.2 SSD on FMC board-to-board connector☆14Updated 2 years ago
- It started as some general experiments with RF stuff and gradually evolved into a (severely limited) spectrum analyzer.☆48Updated 6 years ago
- The FPGA design for the FreeSRP's Artix 7 FPGA☆25Updated 8 years ago
- Streaming video over USB 3.0 using MAX10 FPGA and CYUSB3014 synchronous slave mode.☆22Updated 4 years ago
- Design, Documentation, Schematic, Board, Code files for the FPGA Oscilloscope project using an Altera Cyclone III FPGA.☆115Updated 11 years ago
- Altium PCB project for the Titan PCI Express development card. This card uses the Lattice ECP5 FPGA.☆20Updated 10 years ago