matyay / csi2usbLinks
A CSI to USB "converter" using a Cypress CX3 chip
☆18Updated 5 years ago
Alternatives and similar repositories for csi2usb
Users that are interested in csi2usb are comparing it to the libraries listed below
Sorting:
- Firmware to drive Cypress CX3 camera controller☆25Updated 8 years ago
- IP Camera with S3 SOC from Allwinner, PoE Gigabit, LCD, micro SD, Flash☆40Updated 5 years ago
- Main Probe Scope PCB Repo☆57Updated 6 years ago
- Firmware for 3 Phase BLDC controller☆41Updated 5 years ago
- TO247 half bridge module for EVs☆16Updated 6 years ago
- This is an Arduino based program for step motor controller,Ananas.☆51Updated 8 years ago
- stm32f072 USB-PD standalone firmware☆17Updated 6 years ago
- Alternative firmware for a cheap X-40 laser tape measure☆131Updated 3 months ago
- OpenGrab Electropermanent Magnet☆35Updated 2 years ago
- PCB for Open Thermal Camera☆39Updated 6 years ago
- Photodiode transimpedance amplifier, on a one inch diameter circular PCB☆21Updated last year
- ISL94202 & MSP430 based BMS☆44Updated 5 years ago
- OpenBLDC Strip (STM32F103)☆68Updated 8 years ago
- FPGA Software for the Probe-Scope☆19Updated 6 years ago
- Thermal imaging cameras based on the ESP32 and Lepton 3.5☆127Updated last year
- ☆34Updated 2 years ago
- USB-PD firmware for the stm32f072 - forked from https://git.clayhobbs.com/pd-buddy/pd-buddy-firmware☆31Updated 5 years ago
- ☆16Updated 3 years ago
- ☆16Updated 11 years ago
- Open Source Lab Power Supply☆28Updated 3 years ago
- Firmware for Infinity brushless motor controllers☆26Updated 4 years ago
- Adapter board exposing SATA M.2 SSD on FMC board-to-board connector☆14Updated 2 years ago
- USB Sink based around the STUSB4500☆27Updated 4 years ago
- Hardware files for OtterControl BLDC motor controller☆66Updated 5 years ago
- Open Source 3 Axis Board Design files☆91Updated 11 years ago
- The Trinamic TMC429 is a triple-axis dedicated step and direction motion controller for both position and velocity control with accelerat…☆42Updated 2 months ago
- grbl for stm32 with nucleo stepper drivers☆37Updated 9 years ago
- A utility for converting kicad (.mod, .lib), Eagle (.lbr), gerber (.gbr etc..), BXL (.bxl), IBIS (.ibs), symdef, LT-Spice (.asc), QUCS (.…☆50Updated 2 years ago
- ☆28Updated 8 years ago
- ☆22Updated 8 years ago