MarkDing / Manchester-BMCLinks
Manchester and Biphase Mark Code(BMC) Encoder/Decoder implementation with EFM8LB1 CLU
☆33Updated 9 years ago
Alternatives and similar repositories for Manchester-BMC
Users that are interested in Manchester-BMC are comparing it to the libraries listed below
Sorting:
- ☆46Updated 9 years ago
- CH55x USB to JTAG bridge☆141Updated 9 months ago
- FPGA core boards / evaluation boards based on CDCTL hardware☆93Updated 4 years ago
- ☆79Updated 6 years ago
- USB-JTAG Adapter Using CH552☆70Updated 3 years ago
- Single-chip solution for Hi-speed USB2.0(480Mbps) JTAG/SPI Debugger based on RISC-V MCU CH32V30x/CH32V20x☆118Updated 2 years ago
- x-cube-usb-pd STM32 Expansion Package related to USB-IF Type-C Power Delivery protocol is no more recommended for new design. The USB pow…☆57Updated last year
- Source code of MIPI DSI Bridge Published on https://www.circuitvalley.com☆112Updated last year
- RV-Debugger-BL702 Project, an opensource debugger implement☆209Updated last year
- An open source FPGA design for DSLogic☆168Updated 11 years ago
- Xilinx virtual cable daemon j-link support☆22Updated 9 years ago
- simple DSO over Wi-Fi☆112Updated 9 years ago
- Use gpio to emulate usb low-speed on stm32f030f4p6.Use internal rc instead of crystal.☆35Updated 8 years ago
- Software for the LabTool logic analyzer and oscilloscope☆85Updated 4 years ago
- DMA-accelerated multi-UART USB CDC for STM32F072 microcontroller☆57Updated 6 years ago
- A low cost FPGA/CPLD dev-board based on AG1280Q48.☆70Updated 5 months ago
- Digilent JTAG clone hardware + eeprom firmware (.bin)☆71Updated 3 years ago
- FTDI EEPROM dumps for common JTAG FPGA programmers☆89Updated 2 years ago
- Credit card-sized, USB-powered 4 quadrant source-measure unit hardware and firmware☆123Updated 5 months ago
- SDK sch&layout reference design and datasheet documention☆65Updated last year
- An open source firmware design for DSLogic☆102Updated 11 years ago
- USB to dual UART / SPI / I2C / JTAG / FIFO / Bit-Bang...☆140Updated 3 years ago
- Main Probe Scope PCB Repo☆57Updated 6 years ago
- CH552 Dual USB to Serial Bridge.☆79Updated last year
- An Open-Source CMSIS-DAP Debug Probe based on DAPLink and USB bus convert and it can realize USB convert to serial interface based in CH5…☆95Updated last year
- This is the OpenOCD source code modified to support WCHlink and CH32Vxxx MCUs, received from MounRiver after my GPL request, and publishe…☆18Updated 3 years ago
- a cheap CMSIS-DAP debugger by an WCH chip named CH549F☆48Updated 4 years ago
- The program for USB-Blaster Chinese version on STM32 works with☆33Updated 8 years ago
- Read-only mirror of the official repo at git://sigrok.org/libsigrokdecode. Pull requests welcome. Please file bugreports at sigrok.org/b…☆122Updated last year
- Symbols, footprints and 3d models for use with Altium Designer☆54Updated last year