simmel-project / hardware
Hardware design files for Simmel
☆15Updated 4 years ago
Alternatives and similar repositories for hardware
Users that are interested in hardware are comparing it to the libraries listed below
Sorting:
- Fully isolated, input debounce Hat for Raspberry Pi, for up to 6 switches, relays and powered devices☆23Updated 5 years ago
- ☆19Updated 6 years ago
- Experiments using the RPI Zero GPU for FFT (1D and 2D)☆34Updated 3 years ago
- Display Parallel Interface HAT (Hardware Attached on Top) for Raspberry Pi☆18Updated 4 years ago
- Firmware for the One Inch Oscilloscope☆29Updated 6 years ago
- Simplify and standardize testing of BeagleBoard.org designs☆17Updated last week
- Candy size USB to UART bridge.☆17Updated 4 years ago
- HWR0's Shield Designs for the MorphESP 240 by @ccadic☆12Updated 3 years ago
- UDP control with nano protos over tiny esp8266 TTGO T-Thruster board☆10Updated 4 years ago
- Verilog for the Bus Pirate Ultra FPGA☆26Updated 5 years ago
- Nordic UART Service (NUS) console☆13Updated 6 years ago
- Greybus Module for the Zephyr Real-Time Operating System☆7Updated 2 years ago
- ☆13Updated 2 years ago
- Hardware of Jasper's Electronic Load R2☆21Updated 6 years ago
- 64 bits of core memory and LEDs to interact with directly using a magnetic wand.☆16Updated 4 months ago
- A long and thin development board, designed to keep the number and length of jumper wires to a minimum. Runs Circuit Python on Microchip …☆14Updated last year
- ☆27Updated 4 years ago
- ☆13Updated 3 years ago
- Hacking a cheap IP camera from Banggood☆17Updated 6 years ago
- esp8266 controller based on SVG with embedded links☆10Updated 3 years ago
- Website and protocol specification☆14Updated 3 months ago
- Femto ESP32 Micro USB☆33Updated 4 years ago
- littlefs wrapped in javascript... for some reason...☆39Updated 7 years ago
- Sensything is an ESP32-based IoT device that has multiple sensor interfaces to read from and send data from both analog and digital senso…☆20Updated 6 years ago
- USB 10 digit seven segment display unit☆14Updated 5 years ago
- This repository contains the key code, examples and instructions to get Labview running on the Beagle Bone Black + Robotics Cape, or the …☆12Updated 7 years ago
- Footprints, models and miscellaneous hardware files☆13Updated 6 years ago
- 🧊 Modified M5Stack/MPU9250 gyro/accel demo sketch☆12Updated 4 years ago
- Ghidra processor specification for the Telink TC32☆18Updated 5 years ago
- support files for the 2020 Remoticon KiCad to Blender > PCB renders workshop☆22Updated 4 years ago