Isaac96 / EV-CodeLinks
Arduino projects for the Boxster
☆20Updated 4 years ago
Alternatives and similar repositories for EV-Code
Users that are interested in EV-Code are comparing it to the libraries listed below
Sorting:
- ☆25Updated 10 years ago
- OpenSource Control Unit for the Nissan Leaf Gen 1 and Gen 2 inverter☆61Updated 4 years ago
- An opensource solution for connecting OBD2 straight to the Nissan Leaf battery☆65Updated last year
- The source code for the CAN controller for TC chargers can be found here, as well as the correct library for the MCP chip which works str…☆12Updated 6 years ago
- Generalized Vehicle Reverse Engineering Tool - firmware for Arduino Due based boards☆106Updated 7 years ago
- LEAF CAN bus message decoding with proper database files☆209Updated 6 months ago
- Open Inverter - Alternative Web Interface☆34Updated 3 years ago
- Generalized Electric Vehicle Control Unit☆117Updated 3 years ago
- Software for Damien Maguire's CHAdeMO controller☆23Updated 5 years ago
- ☆177Updated 7 years ago
- ☆20Updated 8 months ago
- Collection of CAN logs from different electric vehicles☆38Updated 3 weeks ago
- Software for correcting instrumentation on a battery "bruteforce" upgraded LEAF☆22Updated 5 years ago
- Reverse Engineering of the BMW SBox for use in ev conversion projects☆13Updated 2 years ago
- Very hacky project that talks to the Nissan Leaf BMS (aka LBC) and to the VW CAN bus☆61Updated 7 months ago
- A Vehicle Control Unit for Electric Vehicle Conversion Projects based on an STM32F107. Software based on the Openinverter Project.☆189Updated this week
- SIMPBMS code for I3 Modules☆46Updated 2 years ago
- leaf spline revers engineering☆14Updated 5 years ago
- Hardware - dingoPDM is an open source, affordable automotive PDM (Power Distribution Module). Pre-assembled and tested units are availabl…☆90Updated last month
- CAN Reverse engineering tool for ESP32 based boards (specifically EVTV ESP32Due)☆333Updated 10 months ago
- Reverse Engineering of the Tesla 10Kw charger and development of an open source control board☆127Updated 4 years ago
- A tool to allow configuration and operating of openinverter systems for electric vehicles over a CAN connection☆23Updated this week
- Web interface for Huebner inverter☆36Updated last year
- An open source TCM for Daimlers 722.6 gearbox. Resource repository☆121Updated last year
- ☆44Updated 3 years ago
- Can bus monitoring tool based on arduino and can bus shield. Implements CAN ASCII/SLCAN protocol compatible with Lawicel CAN232/CANUSB. C…☆327Updated last month
- Wideband Lambda Controller with Bosch CJ125☆42Updated last year
- ☆63Updated last week
- Hardware - CAN enabled small input / output expansion board. Switch panels, steering wheel buttons/knobs, etc.☆45Updated 3 months ago
- Reverse engineering of the on board charger (OBC) used in MG Electric Vehicles☆20Updated 4 months ago