oelprinz-org / BL49SPLinks
Wideband Lambda Controller with Bosch CJ125
☆38Updated last year
Alternatives and similar repositories for BL49SP
Users that are interested in BL49SP are comparing it to the libraries listed below
Sorting:
- Standalone ECU designed for Speeduino and RusEFI firmware.☆40Updated last year
- ☆57Updated 3 weeks ago
- Speeduino compatible engine control unit (ECU) based around black STM32F407VET6 board.☆50Updated last year
- EMS boards powered by Speeduino☆12Updated 5 months ago
- Wideband Lambda Controller with Bosch CJ125 and CAN-Bus Interface☆27Updated last year
- Hardware - dingoPDM is an open source, affordable automotive PDM (Power Distribution Module). Pre-assembled and tested units are availabl…☆80Updated last week
- Wideband lambda controller based on bosch cj125☆12Updated 6 years ago
- blitzBOX - low-cost and mini-sized ECU for speeduino firmware (45 x 58 mm)☆48Updated 4 months ago
- open-source ESP32-based control system designed to manage multiple outputs, monitor temperature, and provide robust control over external…☆16Updated 8 months ago
- ECU designed for Speeduino firmware☆32Updated 5 years ago
- 8Ch EGT sensor board to be used with aftermarket ECUs☆31Updated last year
- EMS boards powered by Speeduino☆86Updated 7 months ago
- Standalone ECU designed for Speeduino firmware☆39Updated 5 years ago
- ☆22Updated 7 years ago
- An Arduino sketch for controlling a Bosch LSU 4.9 Wideband Lambda sensor with minimal parts☆78Updated 11 years ago
- An OLED gauge for the Speeduino ECU. Uses UART (secondary serial) for communication.☆37Updated 2 years ago
- This is an open HW project of Electronic Throttle Controller also known as Drive By Wire.☆47Updated 2 months ago
- Speeduino compatible m5x PnP PCBs☆119Updated 2 weeks ago
- A library of kicad symbols and footprints for parts used across the Speeduino boards☆17Updated last year
- ☆124Updated 4 months ago
- Megasquirt Gauge using CAN bus.☆35Updated 3 years ago
- Please find my custom Speeduino based ECU.☆18Updated 4 years ago
- Arduino Nano based ETC controller implemented with working states☆10Updated 6 years ago
- LIN Example for CWA400☆15Updated last year
- ☆40Updated 4 months ago
- Hardware - CAN enabled small input / output expansion board. Switch panels, steering wheel buttons/knobs, etc.☆37Updated 2 months ago
- Speeduino - Arduino based engine management☆13Updated last month
- DS2 K-line library for Arduino and ESP32☆48Updated 2 months ago
- ☆42Updated 3 years ago
- ECUMaster EMU CAN Stream Reader Arduino Library☆34Updated 2 weeks ago