YuzukiHD / YuzukiRulerPro
YuzukiRulerPro based on Allwinner D1-H RISC-V Processor
☆26Updated 2 years ago
Related projects ⓘ
Alternatives and complementary repositories for YuzukiRulerPro
- A minimum development board for CH32V203G6.☆43Updated 2 years ago
- Yuzuki Rosetta is a low-cost Linux development board based on the R328-S3. Dual-core A7, 128MB RAM, NAND Flash, WI-FI&BT. Raspberry Pi Ze…☆25Updated last year
- YuzukiMavericks is your small USB Flash Driver-shaped Linux development board base on F1C200s☆21Updated 2 years ago
- A low cost FPGA/CPLD dev-board based on AG1280Q48.☆61Updated last year
- A low cost small size USB dev board based on WCH CH552.☆75Updated last year
- L4：Cortex A5 GSM SoC RDA8810☆24Updated 5 years ago
- Buildroot Package for F1C100s/200s☆17Updated 3 years ago
- CH55x USB to JTAG bridge☆125Updated 3 months ago
- Single-chip solution for Hi-speed USB2.0(480Mbps) JTAG/SPI Debugger based on RISC-V MCU CH32V30x/CH32V20x☆96Updated last year
- USB-JTAG Adapter Using CH552☆63Updated 2 years ago
- a daplink made of pi-pico☆25Updated 2 years ago
- a cheap CMSIS-DAP debugger by an WCH chip named CH549F☆45Updated 3 years ago
- SyterKit is a baremetal framework, As bootloader, MPU framework, Running on SRAM☆92Updated last week
- 我的V3S开发包☆16Updated 3 months ago
- Opensource embedded controller firmware for sipeed boards.☆33Updated 5 years ago
- Cherry PI Based On Allwinner V3S Chip☆31Updated 6 years ago
- CH552 Dual USB to Serial Bridge.☆76Updated 3 months ago
- ESC(Electronic Speed Controller) source code based on RISC-V CH32☆28Updated last year
- Longan RV32 Boards Document☆48Updated 4 years ago
- An Open-Source CMSIS-DAP Debug Probe based on DAPLink and USB bus convert and it can realize USB convert to serial interface based in CH5…☆92Updated 3 months ago
- Baremetal LVGL demo on Lichee Nano☆19Updated 3 years ago
- M1s(BL808)SDK☆57Updated last year
- Buildroot Package Mainly for YuzukiHD Devices. Support Allwinner F1C100s/200s V3s V3x D1-H D1s T113 H616 BSP and Mainline☆163Updated last year
- Load bitstream to AG1K series FPGA using CH552☆12Updated 3 years ago
- A CMake framework for GCC compilation☆31Updated last year
- Command-line access to F1C100s GPIO☆24Updated 5 years ago
- Buildroot support for Allwinner V3s/S3/S3L☆40Updated last week
- f1c100s source code☆26Updated 4 years ago