jsphuebner / stm32-CANBootloaderLinks
Bootloader project to update for example STM32F107 / GD32F107 chips
☆18Updated last year
Alternatives and similar repositories for stm32-CANBootloader
Users that are interested in stm32-CANBootloader are comparing it to the libraries listed below
Sorting:
- Hardware - CAN enabled small input / output expansion board. Switch panels, steering wheel buttons/knobs, etc.☆48Updated last month
- CAN bus Library for Arduino STM32☆113Updated 7 months ago
- ☆65Updated last month
- Reverse engineering of the on board charger (OBC) used in MG Electric Vehicles☆20Updated 6 months ago
- Software for Damien Maguire's CHAdeMO controller☆23Updated 5 years ago
- A Vehicle Control Unit for Electric Vehicle Conversion Projects based on an STM32F107. Software based on the Openinverter Project.☆207Updated 2 weeks ago
- Reverse Engineering of the BMW SBox for use in ev conversion projects☆14Updated 2 years ago
- ☆44Updated 3 years ago
- Opensource controller for the Lexus GS450H Hybrid inverter and gearbox☆21Updated 4 years ago
- Collection of CAN logs from different electric vehicles☆40Updated last week
- CAN bus bootloader for AVR microcontrollers attached to an MCP2515 CAN controller.☆39Updated last year
- ☆20Updated 10 months ago
- Volvo LIN bus reader☆100Updated 5 years ago
- ESP32 Based Chademo implementation☆19Updated last year
- leaf spline revers engineering☆14Updated 5 years ago
- OpenSource Control Unit for the Nissan Leaf Gen 1 and Gen 2 inverter☆62Updated 4 years ago
- DS2 K-line library for Arduino and ESP32☆51Updated 9 months ago
- Arduino library to add dual LIN support on SAM3X based boards with a TJA1021/TJA1027 transceiver☆120Updated 7 years ago
- ECUMaster EMU CAN Stream Reader Arduino Library☆39Updated this week
- Provide LIN-Master functions (write and request LIN-Frames via hardware UART☆45Updated last year
- Wideband Lambda Controller with Bosch CJ125 and CAN-Bus Interface☆35Updated last year
- BMW CANbus gateway emulator & proxy☆22Updated 5 years ago
- ESP32-IDF based BLE<->ISO-TP bridge targeting Macchina A0 hardware☆39Updated 3 years ago
- microRusEfi board for rusEfi ECU☆85Updated 4 months ago
- Very hacky project that talks to the Nissan Leaf BMS (aka LBC) and to the VW CAN bus☆64Updated 2 weeks ago
- Hardware - dingoPDM is an open source, affordable automotive PDM (Power Distribution Module). Pre-assembled and tested units are availabl…☆98Updated last week
- CAN (Dual) bus Arduino library for stm32F042, stm32F103, stm32F105, stm32F107, stm32L4, stm32F4☆29Updated 2 years ago
- Fully Open CCS Charge Controller Interface with QCA7005 PLC modem☆95Updated 7 months ago
- Speeduino compatible engine control unit (ECU) based around black STM32F407VET6 board.☆52Updated 2 years ago
- CAN-bus gauge cluster for BMW E12☆14Updated 2 years ago