Autohome2 / dxControl-GearsLinks
☆22Updated 7 years ago
Alternatives and similar repositories for dxControl-Gears
Users that are interested in dxControl-Gears are comparing it to the libraries listed below
Sorting:
- ECU designed for Speeduino firmware☆33Updated 5 years ago
- 8Ch EGT sensor board to be used with aftermarket ECUs☆33Updated last year
- Wideband Lambda Controller with Bosch CJ125☆41Updated last year
- Arduino Nano based ETC controller implemented with working states☆10Updated 6 years ago
- CANBUS implementation for ME7.5 with Arduino Nano and MCP2515☆20Updated 6 years ago
- Speeduino compatible engine control unit (ECU) based around black STM32F407VET6 board.☆50Updated last year
- An Arduino sketch for controlling a Bosch LSU 4.9 Wideband Lambda sensor with minimal parts☆81Updated 12 years ago
- DS2 K-line library for Arduino and ESP32☆51Updated 5 months ago
- WBO2 Controller☆14Updated last year
- Wideband lambda controller based on bosch cj125☆12Updated 6 years ago
- ECUMaster EMU CAN Stream Reader Arduino Teensy 3 and 4 Library☆11Updated 2 years ago
- microRusEfi board for rusEfi ECU☆79Updated this week
- Order a motorized throttle body for gasoline engines with an electronic pedal and an arduino Commander un boitier papillon motorisé des m…☆14Updated 2 months ago
- ☆60Updated 3 weeks ago
- EMS boards powered by Speeduino☆12Updated 3 weeks ago
- Standalone ECU designed for Speeduino firmware☆40Updated 5 years ago
- Dash display project for Megasquirt ECUs based on ESP32 and EVE2☆33Updated 6 years ago
- Peak and hold injector driver for low-Z injectors.☆14Updated 2 years ago
- Hardware - dingoPDM is an open source, affordable automotive PDM (Power Distribution Module). Pre-assembled and tested units are availabl…☆84Updated 3 weeks ago
- Arduino ECU Simulator☆20Updated 6 years ago
- ☆132Updated last week
- An OLED gauge for the Speeduino ECU. Uses UART (secondary serial) for communication.☆38Updated 2 years ago
- An open source TCM for Daimlers 722.6 gearbox. Resource repository☆116Updated 10 months ago
- STM32 based Arduino Mega replacement for speeduino☆101Updated 6 months ago
- ☆43Updated 3 years ago
- ☆13Updated 3 years ago
- Wideband Lambda Controller with Bosch CJ125 and CAN-Bus Interface☆30Updated last year
- Standalone ECU designed for Speeduino and RusEFI firmware.☆45Updated last year
- Jetta TDI aux display☆18Updated 5 years ago
- Hardware - CAN enabled small input / output expansion board. Switch panels, steering wheel buttons/knobs, etc.☆40Updated 3 weeks ago