rusefi / hw_microRusEfiLinks
microRusEfi board for rusEfi ECU
☆76Updated 7 months ago
Alternatives and similar repositories for hw_microRusEfi
Users that are interested in hw_microRusEfi are comparing it to the libraries listed below
Sorting:
- ☆58Updated 3 weeks ago
- User documentation for rusEFI engine control unit☆34Updated this week
- Hardware - dingoPDM is an open source, affordable automotive PDM (Power Distribution Module). Pre-assembled and tested units are availabl…☆81Updated last week
- ☆40Updated 2 weeks ago
- Hardware - CAN enabled small input / output expansion board. Switch panels, steering wheel buttons/knobs, etc.☆39Updated 2 months ago
- An open source TCM for Daimlers 722.6 gearbox. Resource repository☆115Updated 8 months ago
- ☆22Updated 7 years ago
- 8Ch EGT sensor board to be used with aftermarket ECUs☆32Updated last year
- Speeduino compatible engine control unit (ECU) based around black STM32F407VET6 board.☆50Updated last year
- Standalone ECU designed for Speeduino and RusEFI firmware.☆40Updated last year
- MegaTunix Tuning software for MegaSquirt (and others) EFI Controllers☆54Updated 7 years ago
- Free Open Motorsports ECU☆80Updated last week
- CAN Bus logger with SD card implemented using ChibiOS☆70Updated 6 years ago
- VAGCANLOGGER - KW1281 & VW TP 2.0☆33Updated 11 years ago
- An Arduino sketch for controlling a Bosch LSU 4.9 Wideband Lambda sensor with minimal parts☆78Updated 11 years ago
- K-line/Serial/CAN interface and fuel mapper for motorcycles.☆90Updated 5 years ago
- Arduino ECU Simulator☆20Updated 5 years ago
- Generalized Vehicle Reverse Engineering Tool - firmware for Arduino Due based boards☆102Updated 6 years ago
- ECU designed for Speeduino firmware☆32Updated 5 years ago
- ESP32 slcan compatible device☆101Updated 3 years ago
- Wideband Lambda Controller with Bosch CJ125 and CAN-Bus Interface☆27Updated last year
- CAN Bus Bridge / Smart Repeater☆36Updated 3 months ago
- Wideband Lambda Controller with Bosch CJ125☆38Updated last year
- ☆126Updated 4 months ago
- Designs for the Macchina M2☆92Updated 4 years ago
- This is an Open Source Hardware USB to CAN-FD Interface☆66Updated 4 months ago
- Arduino library to add dual LIN support on SAM3X based boards with a TJA1021/TJA1027 transceiver☆114Updated 6 years ago
- Eagle schematics of inverter main board, sensor boards and gate drivers☆67Updated 2 years ago
- Open Source CAN bus Analyser and Simulation Software☆62Updated 2 months ago
- Jetta TDI aux display☆18Updated 5 years ago