digmorepaka / speeduino-mini-2-channelLinks
A 75x78mm speeduino board featuring robotdyn mega 2560 pro microcontroller and all the basics needed to get a 2 channel setup. This is meant for simple engines like motorcycle 1cyls and V-Twins
☆15Updated 4 years ago
Alternatives and similar repositories for speeduino-mini-2-channel
Users that are interested in speeduino-mini-2-channel are comparing it to the libraries listed below
Sorting:
- Automatic Transmission Controller designed by Seaside Customs Garage☆14Updated 7 years ago
- Arduino Nano based ETC controller implemented with working states☆10Updated 7 years ago
- Sofrware to tuning ME7.xx Family☆13Updated 3 years ago
- ECU designed for Speeduino firmware☆35Updated 6 years ago
- Hardware is based off an open source project called Speeduino by Josh Stewart.☆15Updated 7 months ago
- Car OBD gauges Arduino TFT☆25Updated last year
- ☆25Updated 7 years ago
- Coil On Plug Project made with Arduino Nano V3 for Honda/Acura☆13Updated 2 years ago
- blitzBOX - low-cost and mini-sized ECU for speeduino firmware (45 x 58 mm)☆53Updated 11 months ago
- Order a motorized throttle body for gasoline engines with an electronic pedal and an arduino Commander un boitier papillon motorisé des m…☆15Updated 6 months ago
- Dash display project for Megasquirt ECUs based on ESP32 and EVE2☆34Updated 6 years ago
- 8Ch EGT sensor board to be used with aftermarket ECUs☆34Updated last year
- ☆14Updated 3 years ago
- An Arduino-powered automotive gauge using OBDII.☆11Updated 4 years ago
- Read and write your Volvo ECU (Bosch ME7) using a DiCE cable. Early working version assembled from various abandoned projects. Its old an…☆21Updated 2 years ago
- Standalone ECU designed for Speeduino and RusEFI firmware.☆53Updated 2 years ago
- Speeduino compatible engine control unit (ECU) based around black STM32F407VET6 board.☆52Updated 2 years ago
- Standalone ECU designed for Speeduino firmware☆42Updated 5 years ago
- Arduino ECU Simulator☆21Updated 6 years ago
- ☆44Updated 6 months ago
- An OLED gauge for the Speeduino ECU. Uses UART (secondary serial) for communication.☆39Updated 2 years ago
- Hellen-One Hardware Platform for rusEFI Engine Management System☆26Updated 3 weeks ago
- *on hold * Implement J2534 interface with a cheep Chinese elm327 copy (pic18f25k80)☆19Updated 7 years ago
- CANBUS implementation for ME7.5 with Arduino Nano and MCP2515☆20Updated 7 years ago
- Wideband Lambda Controller with Bosch CJ125☆43Updated 2 years ago
- WBO2 Controller☆15Updated last year
- Arduino based 2Step Launch Control Module similar to Bee*R for Honda/Acura☆12Updated 5 years ago
- User documentation for rusEFI engine control unit☆47Updated this week
- Hacking a Vehicles CanBus☆25Updated 3 years ago
- EMS boards powered by Speeduino☆96Updated 3 months ago