FRAMSPEEDUINO / CUSTOM_SPEEDUINO_ECULinks
Please find my custom Speeduino based ECU.
☆19Updated 5 years ago
Alternatives and similar repositories for CUSTOM_SPEEDUINO_ECU
Users that are interested in CUSTOM_SPEEDUINO_ECU are comparing it to the libraries listed below
Sorting:
- An OLED gauge for the Speeduino ECU. Uses UART (secondary serial) for communication.☆39Updated 2 years ago
- Standalone ECU designed for Speeduino firmware☆42Updated 5 years ago
- EMS boards powered by Speeduino☆96Updated 3 months ago
- ☆12Updated 5 years ago
- ECU designed for Speeduino firmware☆35Updated 5 years ago
- This is a Oled based speeduino display that polls data over Serial3☆16Updated 5 years ago
- Standalone ECU designed for Speeduino and RusEFI firmware.☆53Updated 2 years ago
- Speeduino compatible engine control unit (ECU) based around black STM32F407VET6 board.☆52Updated 2 years ago
- EMS boards powered by Speeduino☆12Updated 4 months ago
- Wideband lambda controller based on bosch cj125☆12Updated 6 years ago
- ☆155Updated 2 months ago
- blitzBOX - low-cost and mini-sized ECU for speeduino firmware (45 x 58 mm)☆53Updated 11 months ago
- Official Speeduino hardware designs☆236Updated last year
- ☆19Updated 6 years ago
- STM32 based Arduino Mega replacement for speeduino☆112Updated 3 months ago
- This is an open HW project of Electronic Throttle Controller also known as Drive By Wire.☆53Updated 9 months ago
- ☆14Updated 3 years ago
- This is a LCD based speeduino display that polls data over Serial3☆20Updated 5 years ago
- ☆25Updated 7 years ago
- Arduino Nano based ETC controller implemented with working states☆10Updated 7 years ago
- Open source/hardware LSU 4.9 wideband controller☆18Updated 7 years ago
- STM32-based data display and logger for Speeduino SecondarySerial.☆13Updated 4 years ago
- Zero Motorcycles alternative dashboard using a tft and the canbus and an Adafruit Esp32☆15Updated 4 years ago
- Wideband Lambda Controller with Bosch CJ125☆43Updated 2 years ago
- Hardware - dingoPDM is an open source, affordable automotive PDM (Power Distribution Module). Pre-assembled and tested units are availabl…☆97Updated last week
- Free Open Motorsports ECU☆95Updated this week
- 8Ch EGT sensor board to be used with aftermarket ECUs☆34Updated last year
- CANBUS implementation for ME7.5 with Arduino Nano and MCP2515☆20Updated 7 years ago
- Megasquirt Gauge using CAN bus.☆35Updated 3 years ago
- Hardware is based off an open source project called Speeduino by Josh Stewart.☆15Updated 7 months ago