speeduino / HardwareLinks
Official Speeduino hardware designs
☆229Updated last year
Alternatives and similar repositories for Hardware
Users that are interested in Hardware are comparing it to the libraries listed below
Sorting:
- EMS boards powered by Speeduino☆93Updated last month
- STM32 based Arduino Mega replacement for speeduino☆110Updated last month
- ☆145Updated 3 weeks ago
- Speeduino compatible engine control unit (ECU) based around black STM32F407VET6 board.☆51Updated last year
- Speeduino compatible m5x PnP PCBs☆130Updated last month
- This is an open HW project of Electronic Throttle Controller also known as Drive By Wire.☆51Updated 8 months ago
- Speeduino universal firmware loader☆53Updated 7 months ago
- An OLED gauge for the Speeduino ECU. Uses UART (secondary serial) for communication.☆39Updated 2 years ago
- Hardware - dingoPDM is an open source, affordable automotive PDM (Power Distribution Module). Pre-assembled and tested units are availabl…☆90Updated 2 months ago
- Standalone ECU designed for Speeduino and RusEFI firmware.☆51Updated last year
- ☆63Updated 2 weeks ago
- This is a LCD based speeduino display that polls data over Serial3☆20Updated 4 years ago
- blitzBOX - low-cost and mini-sized ECU for speeduino firmware (45 x 58 mm)☆53Updated 10 months ago
- EMS boards powered by Speeduino☆12Updated 3 months ago
- A library of kicad symbols and footprints for parts used across the Speeduino boards☆20Updated last year
- Free Open Motorsports ECU☆95Updated 2 weeks ago
- An Arduino sketch for controlling a Bosch LSU 4.9 Wideband Lambda sensor with minimal parts☆82Updated 12 years ago
- Official and user contributed base tunes for Speeduino installations☆40Updated 9 months ago
- ECU designed for Speeduino firmware☆35Updated 5 years ago
- rusEFI open source lowcost CAN-bus dashboard☆17Updated 2 weeks ago
- Please find my custom Speeduino based ECU.☆19Updated 4 years ago
- ☆18Updated 6 years ago
- Wideband Lambda Controller with Bosch CJ125☆42Updated last year
- microRusEfi board for rusEfi ECU☆84Updated 3 months ago
- ☆11Updated 9 months ago
- 8Ch EGT sensor board to be used with aftermarket ECUs☆34Updated last year
- Hardware - CAN enabled small input / output expansion board. Switch panels, steering wheel buttons/knobs, etc.☆45Updated 3 months ago
- Speeduino - Arduino based engine management☆16Updated last month
- ☆14Updated 3 years ago
- Standalone ECU designed for Speeduino firmware☆42Updated 5 years ago