Tjeerdie / Peak-And-hold-DriverLinks
Peak and hold injector driver for low-Z injectors.
☆14Updated 3 years ago
Alternatives and similar repositories for Peak-And-hold-Driver
Users that are interested in Peak-And-hold-Driver are comparing it to the libraries listed below
Sorting:
- Speeduino compatible engine control unit (ECU) based around black STM32F407VET6 board.☆51Updated last year
- ☆25Updated 7 years ago
- Order a motorized throttle body for gasoline engines with an electronic pedal and an arduino Commander un boitier papillon motorisé des m…☆15Updated 5 months ago
- Arduino Nano based ETC controller implemented with working states☆10Updated 7 years ago
- WBO2 Controller☆15Updated last year
- ECUMaster EMU CAN Stream Reader Arduino Teensy 3 and 4 Library☆11Updated 3 years ago
- microRusEfi board for rusEfi ECU☆84Updated 3 months ago
- Dash display project for Megasquirt ECUs based on ESP32 and EVE2☆33Updated 6 years ago
- Wideband Lambda Controller with Bosch CJ125☆43Updated last year
- ECU designed for Speeduino firmware☆35Updated 5 years ago
- 8Ch EGT sensor board to be used with aftermarket ECUs☆34Updated last year
- Arduino ECU Simulator☆21Updated 6 years ago
- ☆152Updated last month
- Hardware - dingoPDM is an open source, affordable automotive PDM (Power Distribution Module). Pre-assembled and tested units are availabl…☆94Updated 3 weeks ago
- Standalone ECU designed for Speeduino and RusEFI firmware.☆51Updated last year
- A library of kicad symbols and footprints for parts used across the Speeduino boards☆20Updated last year
- ☆64Updated 2 weeks ago
- Arduino/Teensy CAN Gauges with OLED displays☆16Updated 7 years ago
- User documentation for rusEFI engine control unit☆45Updated this week
- EMS boards powered by Speeduino☆12Updated 4 months ago
- Megasquirt Gauge using CAN bus.☆35Updated 3 years ago
- Wideband Lambda Controller with Bosch CJ125 and CAN-Bus Interface☆34Updated last year
- ☆14Updated 3 years ago
- Hardware - CAN enabled small input / output expansion board. Switch panels, steering wheel buttons/knobs, etc.☆45Updated 3 weeks ago
- ☆44Updated 6 months ago
- STM32 based Arduino Mega replacement for speeduino☆112Updated 2 months ago
- Sofrware to tuning ME7.xx Family☆13Updated 3 years ago
- Please find my custom Speeduino based ECU.☆19Updated 5 years ago
- ECUHost OS For Rabbit ECU With HAL And Arduino Due Controller Port☆11Updated 2 years ago
- ☆33Updated 2 months ago