AmesisProject / 002-Amesis-Throttle_To_ThrottleBody_ArduinoLinks
Order a motorized throttle body for gasoline engines with an electronic pedal and an arduino Commander un boitier papillon motorisé des moteur essence avec une pédale électronique et un arduino
☆15Updated 7 months ago
Alternatives and similar repositories for 002-Amesis-Throttle_To_ThrottleBody_Arduino
Users that are interested in 002-Amesis-Throttle_To_ThrottleBody_Arduino are comparing it to the libraries listed below
Sorting:
- Arduino Nano based ETC controller implemented with working states☆10Updated 7 years ago
- ECU designed for Speeduino firmware☆35Updated 6 years ago
- ☆25Updated 8 years ago
- Speeduino compatible engine control unit (ECU) based around black STM32F407VET6 board.☆52Updated 2 years ago
- Sofrware to tuning ME7.xx Family☆13Updated 3 years ago
- ECUMaster EMU CAN Stream Reader Arduino Teensy 3 and 4 Library☆11Updated 3 years ago
- Wideband Lambda Controller with Bosch CJ125☆45Updated 2 years ago
- WBO2 Controller☆17Updated last year
- 8Ch EGT sensor board to be used with aftermarket ECUs☆35Updated last year
- A 75x78mm speeduino board featuring robotdyn mega 2560 pro microcontroller and all the basics needed to get a 2 channel setup. This is me…☆15Updated 4 years ago
- Dash display project for Megasquirt ECUs based on ESP32 and EVE2☆35Updated 6 years ago
- An OLED gauge for the Speeduino ECU. Uses UART (secondary serial) for communication.☆40Updated 3 years ago
- ☆12Updated 5 years ago
- Standalone ECU designed for Speeduino and RusEFI firmware.☆54Updated 2 years ago
- Open source/hardware LSU 4.9 wideband controller☆18Updated 7 years ago
- ☆15Updated 3 years ago
- CANBUS implementation for ME7.5 with Arduino Nano and MCP2515☆20Updated 7 years ago
- EMS boards powered by Speeduino☆98Updated 3 months ago
- Peak and hold injector driver for low-Z injectors.☆14Updated 3 years ago
- Arduino ECU Simulator☆21Updated 6 years ago
- project arduino to clean solenoid injector of engin car☆26Updated 4 years ago
- Coil On Plug Project made with Arduino Nano V3 for Honda/Acura☆13Updated 3 years ago
- Standalone ECU designed for Speeduino firmware☆42Updated 5 years ago
- A dash project for tunerstudio based on RASPBIAN☆31Updated last year
- EMS boards powered by Speeduino☆12Updated 5 months ago
- ☆156Updated last week
- Please find my custom Speeduino based ECU.☆19Updated 5 years ago
- An Arduino-powered automotive gauge using OBDII.☆11Updated 4 years ago
- A library of kicad symbols and footprints for parts used across the Speeduino boards☆20Updated last year
- ☆28Updated 3 years ago