geraldjust / Ignition-Coil-uC-AdapterLinks
☆10Updated 4 years ago
Alternatives and similar repositories for Ignition-Coil-uC-Adapter
Users that are interested in Ignition-Coil-uC-Adapter are comparing it to the libraries listed below
Sorting:
- Arduino Nano based ETC controller implemented with working states☆10Updated 7 years ago
- ☆27Updated 3 years ago
- WBO2 Controller☆15Updated last year
- 8Ch EGT sensor board to be used with aftermarket ECUs☆34Updated last year
- ☆23Updated 7 years ago
- project arduino to clean solenoid injector of engin car☆25Updated 4 years ago
- ☆42Updated 5 years ago
- Order a motorized throttle body for gasoline engines with an electronic pedal and an arduino Commander un boitier papillon motorisé des m…☆14Updated 4 months ago
- Hardware and software for interfacing Chrysler's legacy CCD/PCI/SCI-bus.☆69Updated last month
- A 75x78mm speeduino board featuring robotdyn mega 2560 pro microcontroller and all the basics needed to get a 2 channel setup. This is me…☆15Updated 4 years ago
- Sofrware to tuning ME7.xx Family☆13Updated 3 years ago
- Dash display project for Megasquirt ECUs based on ESP32 and EVE2☆33Updated 6 years ago
- Arduino Injector Tester☆14Updated 8 years ago
- Car Dashboard using Arduino Leonardo, OBDII to UART adapter and Intelligent Nextion Display☆36Updated last year
- ECUMaster EMU CAN Stream Reader Arduino Teensy 3 and 4 Library☆11Updated 2 years ago
- Wideband Lambda Controller with Bosch CJ125☆42Updated last year
- ECU designed for Speeduino firmware☆35Updated 5 years ago
- Low cost DIY open source MegaSquirt derivative.☆16Updated 8 years ago
- Arduino library to work with LCD via HT1621 controller☆12Updated 3 years ago
- ☆63Updated 11 months ago
- Wideband Lambda Controller with Bosch CJ125 and CAN-Bus Interface☆33Updated last year
- An Arduino library for reading OBD-II data from your car over CAN bus☆55Updated last year
- Arduino ECU Simulator☆21Updated 6 years ago
- ☆43Updated 5 months ago
- Full digital monitoring of classic car with coolant fan control with Arduino Mega☆15Updated 9 years ago
- CANBUS implementation for ME7.5 with Arduino Nano and MCP2515☆20Updated 6 years ago
- Car OBD gauges Arduino TFT☆23Updated last year
- An Arduino-powered automotive gauge using OBDII.☆11Updated 4 years ago
- An 02/lambda eliminator/simulator to tune an engine ECU in closed loop mode.☆17Updated 10 years ago
- User documentation for rusEFI engine control unit☆42Updated this week