cahumphrey83 / Miata-Dash
Raspberry Pi powered digital dash using a 7" touchscreen display and TunerStudio.
☆13Updated 3 years ago
Alternatives and similar repositories for Miata-Dash:
Users that are interested in Miata-Dash are comparing it to the libraries listed below
- Order a motorized throttle body for gasoline engines with an electronic pedal and an arduino Commander un boitier papillon motorisé des m…☆13Updated last year
- Megasquirt CAN Protocol with Arduino☆31Updated last year
- Arduino Nano based ETC controller implemented with working states☆10Updated 6 years ago
- open-source ESP32-based control system designed to manage multiple outputs, monitor temperature, and provide robust control over external…☆16Updated 3 months ago
- Volumetric flow bench based on ESP32 and MAF sensor.☆29Updated this week
- Megasquirt Gauge using CAN bus.☆31Updated 2 years ago
- utility to dump the Mazda RX8 (and maybe others) ECU firmware☆28Updated 2 years ago
- haha subaru wrx go brrrr☆42Updated 4 years ago
- Megasquirt Gauge based on Arduino Mega, MCP2515 Transceiver, OLED Screen and Neopixel LED Ring.☆15Updated 2 years ago
- ☆11Updated 3 weeks ago
- An Arduino sketch and schematic for the hardware to drive a BMW instrument cluster over CAN-BUS, KBUS and general IO lines. The firmware …☆34Updated 9 years ago
- Official and user contributed base tunes for Speeduino installations☆35Updated 8 months ago
- ECUMaster EMU CAN Stream Reader Arduino Library☆32Updated this week
- An Arduino sketch for controlling a Bosch LSU 4.9 Wideband Lambda sensor with minimal parts☆72Updated 11 years ago
- ☆11Updated 5 years ago
- An OLED gauge for the Speeduino ECU. Uses UART (secondary serial) for communication.☆34Updated 2 years ago
- ☆17Updated 5 years ago
- This is an open HW project of Electronic Throttle Controller also known as Drive By Wire.☆42Updated 2 months ago
- EMS boards powered by Speeduino☆82Updated 2 months ago
- Raspberry Pi / Teensy based Digital Gauge Cluster☆64Updated last year
- This code runs on an Arduino device, and is designed to run as a replacement for the ECU in a Mazda Mark 1 RX8. There are many variation…☆48Updated 4 years ago
- BMW I/K-Bus Documentation☆95Updated last month
- MegaTunix Tuning software for MegaSquirt (and others) EFI Controllers☆52Updated 6 years ago
- Hardware - CAN enabled IO board☆29Updated last month
- ☆11Updated 2 years ago
- Standalone ECU designed for Speeduino firmware☆38Updated 4 years ago
- ECU designed for Speeduino firmware☆30Updated 5 years ago
- Free Open Motorsports ECU☆61Updated last week
- ☆22Updated last year
- Wideband lambda controller based on bosch cj125☆12Updated 5 years ago