Alternatives and similar repositories for gowin_flipflop_drainer

Users that are interested in gowin_flipflop_drainer are comparing it to the libraries listed below

• nand2mario / usb_hid_host
  A compact USB HID host FPGA core supporting keyboards, mice and gamepads.
  ☆141Updated 7 months ago
• splinedrive / my_hdmi_device
  New clean hdmi implementation for ulx3s, icestick, icoboard, arty7, colorlight i5 and blackicemx! With tmds encoding hacked down from dvi…
  ☆104Updated 2 months ago
• no2fpga / no2bootloader
  USB DFU bootloader gateware / firmware for FPGAs
  ☆69Updated last year
• zf3 / psram-tang-nano-9k
  An open source PSRAM/HyperRAM controller for Sipeed Tang Nano 9K / Gowin GW1NR-LV9QN88PC6/15 FPGA
  ☆83Updated 3 years ago
• kazkojima / colorlight-i5-tips
  Tiny tips for Colorlight i5 FPGA board
  ☆58Updated 4 years ago
• kholia / Colorlight-5A-75B
  Notes for Colorlight-5A-75B.
  ☆49Updated 11 months ago
• ultraembedded / openlogicbit
  Open-source Logic Analyzer gateware for various FPGA dev boards/replacement gateware for commercially available logic analyzers.
  ☆156Updated 4 years ago
• joshajohnson / ecp5-mini
  ECP5 FPGA in an "S7 Mini" form factor
  ☆88Updated 4 years ago
• Ravenslofty / mistral
  Cyclone V bitstream reverse-engineering project
  ☆124Updated 2 years ago
• nand2mario / ddr3-tang-primer-20k
  DDR3 controller for Tang Primer 20K (Gowin GW2A-18C fpga). DDR3-800 speed and low latency.
  ☆61Updated 2 years ago
• TimRudy / ice-chips-verilog
  IceChips is a library of all common discrete logic devices in Verilog
  ☆150Updated last month
• hi631 / tang-nano-9K
  ☆101Updated 2 years ago
• smunaut / iCE40linux
  Gateware / Firmware / BuildRoot to run linux on iCE40 / iCEBreaker
  ☆101Updated 2 years ago
• Ravenslofty / 74xx-liberty
  ☆69Updated 2 years ago
• emard / ulx3s-misc
  Miscellaneous ULX3S examples (advanced)
  ☆81Updated 4 months ago
• no2fpga / no2usb
  Nitro USB FPGA core
  ☆85Updated last year
• abhra0897 / gowin-easy-linux
  Easy setup of GoWin FPGA SDK on Linux. A single script (main_launcher) automates all the critical steps and quickly fires up the IDE.
  ☆24Updated 5 years ago
• openXC7 / toolchain-installer
  Convenience script to install the nextpnr-xilinx toolchain for Kintex7, Artix7, Spartan7 and Zynq7
  ☆92Updated 4 months ago
• gregdavill / ecpprog
  Programmer for the Lattice ECP5 series, making use of FTDI based adaptors
  ☆90Updated last year
• mattvenn / basic-ecp5-pcb
  Reference design for Lattice ECP5 FPGA. Featuring Raspberry Pi interface and 6 PMODs
  ☆120Updated 4 years ago
• openXC7 / demo-projects
  Demo projects for various Kintex FPGA boards
  ☆64Updated 5 months ago
• mmicko / prjtang
  Documenting the Anlogic FPGA bit-stream format.
  ☆88Updated 2 years ago
• riktw / tang4Kramblings
  ☆21Updated 4 years ago
• juj / gowin_fpga_code_generators
  Interactive code generators for Gowin FPGAs
  ☆18Updated 2 years ago
• blackmesalabs / hyperram
  Portable Verilog RTL interface to S27KL0641DABHI020 64Mbit HyperRAM IC
  ☆91Updated 7 years ago
• Wallbraker / SODIMM
  Sodimm components for KiCad
  ☆42Updated 4 years ago
• davidthings / tinyfpga_bx_usbserial
  USB Serial on the TinyFPGA BX
  ☆135Updated 4 years ago
• StereoNinja / StereoNinjaFPGA
  Experimental FPGA project for streaming two MIPI CSI camera streams to an HDMI monitor using a ULX3S FPGA board
  ☆32Updated 2 years ago
• defparam / PCI2Nano-RTL
  An open source FPGA PCI core & 8250-Compatible PCI UART core
  ☆44Updated 4 years ago
• ZiyangYE / General-Slow-DDR3-Interface
  A general slow DDR3 interface. Very little resource consumption. Suits for all FPGAs with 1.5V IO voltage.
  ☆38Updated last year