kmpelectronics / Arduino
KMP Electronics Ltd, Arduino projects
☆12Updated 2 years ago
Alternatives and similar repositories for Arduino:
Users that are interested in Arduino are comparing it to the libraries listed below
- DALI Master Particle library for use with LED-Warrior-14☆17Updated 2 years ago
- ☆20Updated 11 years ago
- ☆24Updated 8 years ago
- 1-wire library for ESP8266☆11Updated 4 years ago
- Arduino Pro Mini ICSP and FTDI Programming Board☆22Updated 7 years ago
- Arduino OneWire DS2438 device library.☆20Updated 6 years ago
- Master code for slave devices☆18Updated 5 years ago
- A class to collect data from a energy monitor that uses modbus protocol.☆46Updated 4 years ago
- Support for Texas Instruments CC Debugger in Linux☆12Updated 9 months ago
- An arduino library that implements the CC.Debugger protocol of TI☆23Updated 5 years ago
- Arduino (AVR/ATTiny) based slave projects for ESP Easy☆22Updated 8 years ago
- ARM based Smarthome 4x RF Transceiver w/wo LAN for 433 or 868 MHz and 2 free UARTS☆11Updated last year
- ☆26Updated last year
- ☆13Updated 5 years ago
- ESP8266 and sx1276 LoRaWan☆13Updated 6 years ago
- DitroniX IPEM ESP32 ATM90E32 ATM90E36 AT24C64 CH340 IoT Power Energy Monitor Board SDK☆19Updated 2 weeks ago
- LaCrosseITPlusReader from FHEM sourceforge.net. Now on ESP32 LORA (SX1276 is same as RFM96)☆15Updated 2 years ago
- Our DMX light controller☆17Updated 8 years ago
- Full-featured Serial bridge for ESP8266, supports MQTT, WebSockets,Telnet, and also comes with a nice Config Page☆39Updated last year
- Generic library for any voltage and current sensors. Interrupt based, implements a zero cross detector and phase-locked loop for better p…☆27Updated 8 years ago
- !!!!! THIS IS AN MIRROR OF A GITLAB HOSTED PROJECT !!!!!☆20Updated 3 years ago
- Here is a way to setup an anemometer that works with RS485 MODBUS communication protocol☆14Updated last year
- A library for handling communication through the Semtech SX1276/7/8/9 devices.☆8Updated 4 years ago
- Control your lamps with a Dali shield for Arduino™☆48Updated last year
- Burn HM-10 (CC2541) and Zigbee (CC2530 CC2531) firmware using NodeMCU board.☆40Updated 4 years ago
- Arduino software for an electronically controlled load, based on a STM32 microcontroller☆21Updated 4 years ago
- Easy MultiSensor device based on ESP8266 using MySensors library☆22Updated 9 years ago
- Arduino, grab Onewire Temperature's and publish to a mqtt broker.☆14Updated 9 years ago
- ESP8266 - based Vaillant boiler E-Bus monitor, temperature/pressure publishing to Narodmon.ru☆46Updated 2 years ago
- ☆16Updated 5 years ago