DeeEmm / DIY-Flow-BenchLinks
Volumetric flow bench based on ESP32 and MAF sensor.
☆35Updated 3 months ago
Alternatives and similar repositories for DIY-Flow-Bench
Users that are interested in DIY-Flow-Bench are comparing it to the libraries listed below
Sorting:
- ☆145Updated 3 weeks ago
- EMS boards powered by Speeduino☆93Updated last month
- Zero Motorcycles alternative dashboard using a tft and the canbus and an Adafruit Esp32☆15Updated 3 years ago
- This is an open HW project of Electronic Throttle Controller also known as Drive By Wire.☆51Updated 8 months ago
- Official Speeduino hardware designs☆230Updated last year
- STM32 based Arduino Mega replacement for speeduino☆110Updated 2 months ago
- Speeduino compatible engine control unit (ECU) based around black STM32F407VET6 board.☆51Updated last year
- An OLED gauge for the Speeduino ECU. Uses UART (secondary serial) for communication.☆39Updated 2 years ago
- Wideband Lambda Controller with Bosch CJ125☆42Updated last year
- Arduino/Teensy CAN Gauges with OLED displays☆16Updated 7 years ago
- haha subaru wrx go brrrr☆43Updated 5 years ago
- ☆24Updated 7 years ago
- An Arduino sketch for controlling a Bosch LSU 4.9 Wideband Lambda sensor with minimal parts☆82Updated 12 years ago
- blitzBOX - low-cost and mini-sized ECU for speeduino firmware (45 x 58 mm)☆53Updated 10 months ago
- Hardware - dingoPDM is an open source, affordable automotive PDM (Power Distribution Module). Pre-assembled and tested units are availabl…☆91Updated this week
- EMS boards powered by Speeduino☆12Updated 3 months ago
- Speeduino universal firmware loader☆53Updated 8 months ago
- Speeduino compatible m5x PnP PCBs☆130Updated 2 months ago
- A dash project for tunerstudio based on RASPBIAN☆30Updated 10 months ago
- Standalone ECU designed for Speeduino and RusEFI firmware.☆51Updated last year
- Files for my experiments with Electronic Fuel Injection on the dune buggy will be posted here.☆76Updated 6 months ago
- Please find my custom Speeduino based ECU.☆19Updated 4 years ago
- ☆11Updated 9 months ago
- Dash display project for Megasquirt ECUs based on ESP32 and EVE2☆33Updated 6 years ago
- 8Ch EGT sensor board to be used with aftermarket ECUs☆34Updated last year
- Custom Turbo Boost Gauge using ESP32S3 with Round Waveshare IPS Display☆122Updated last year
- A library of kicad symbols and footprints for parts used across the Speeduino boards☆20Updated last year
- ☆63Updated 2 weeks ago
- Standalone ECU designed for Speeduino firmware☆42Updated 5 years ago
- Arduino Nano based ETC controller implemented with working states☆10Updated 7 years ago