JSpiner / ThermalScopeLinks
ESP32 + Lepton based Toy Thermal Scope Project
☆11Updated 2 years ago
Alternatives and similar repositories for ThermalScope
Users that are interested in ThermalScope are comparing it to the libraries listed below
Sorting:
- Low Cost DIY Laser XY Scanner, Cutter, or Engraver☆41Updated 11 months ago
- DIY RC Transmitter☆28Updated 4 years ago
- Dual brushed motor ESC firmware compatible with brushless motor ESCs☆33Updated last year
- Battery tester with arduino, with thermistor to check temperature of power resistance and battery. On version 0.2 now It's possible to se…☆27Updated last year
- Motorized zoom lens controller Kurokesu SCF4 module featuring STM32 controller and Onsemi LC898201 driver control software☆30Updated last year
- MIG Welder Controller☆10Updated 10 years ago
- A variant of the MP2 electronic speed control with DFNW MOSFETs☆25Updated last year
- A Configurable Electrochemical Machining Modification☆18Updated 3 years ago
- DIY Multiprotocol TX Module☆15Updated 9 months ago
- ☆28Updated last year
- Motorized solder paste dispenser☆27Updated 2 years ago
- ☆13Updated 2 years ago
- Battery Health Monitor A compact device for monitoring the State of Health (SoH) and State of Charge (SoC) of lithium batteries. It uses …☆32Updated 7 months ago
- Hot air rework controller for generic 858D / 8586 / 8858 / 852 / 878 / 858 hot air guns from China.☆31Updated 5 years ago
- Modified version of original dRehmFlight VTOL for the flying RC drift car☆34Updated last year
- An STM32F4-based 3D printer control board, designed to be fast, quiet, and compact.☆22Updated 6 years ago
- Lathe electronic leadscrew controller☆15Updated 5 years ago
- Open source firmware for the Matek 1.3 GHz +28 dBm Analog Video Transmitter☆12Updated 5 years ago
- ☆77Updated last year
- ESP8266 reflow controller☆26Updated 3 years ago
- 3D printable - DIY microscope☆14Updated 7 years ago
- OpenTX support for STM32F407VET6☆26Updated 5 years ago
- The open source powder trickler solution with DIY hardware and software.☆76Updated last week
- ☆18Updated 3 years ago
- A jogwheel based pendant controller to interface to Marlin / Arduino controlled 3D printers & CNCs☆15Updated 5 years ago
- ESP32-based portable Multi-Sensor Pod [in development]☆10Updated last year
- OpenAVRc Hardware and addons☆23Updated this week
- Arduino / ESP32 project for controlling lights on an rc car base on rc receiver values.☆20Updated 4 years ago
- A 75x78mm speeduino board featuring robotdyn mega 2560 pro microcontroller and all the basics needed to get a 2 channel setup. This is me…☆15Updated 4 years ago
- Digital Test board for an Open Source FPGA Oscilloscope☆20Updated 5 years ago