14Point7 / SLC-FreeLinks
This project is still regularly updated, though not through Github. Github is a nightmare for me to use, nothing syncs correctly, none of my commits show up, it is forcing me to upgrade from windows xp. I am going to make the project directly downloadable from my website, http://www.14point7.com/pages/software-and-documentation
☆19Updated 6 years ago
Alternatives and similar repositories for SLC-Free
Users that are interested in SLC-Free are comparing it to the libraries listed below
Sorting:
- Arduino Nano based ETC controller implemented with working states☆10Updated 7 years ago
- Wide band oxygen sensor controller - a tribute to 14point7 SLC Free☆16Updated last year
- ☆12Updated 5 years ago
- ECU designed for Speeduino firmware☆35Updated 6 years ago
- Order a motorized throttle body for gasoline engines with an electronic pedal and an arduino Commander un boitier papillon motorisé des m…☆15Updated 7 months ago
- Speeduino compatible engine control unit (ECU) based around black STM32F407VET6 board.☆52Updated 2 years ago
- EMS boards powered by Speeduino☆98Updated 3 months ago
- STM32 based Arduino Mega replacement for speeduino☆113Updated 4 months ago
- ☆25Updated 8 years ago
- blitzBOX - low-cost and mini-sized ECU for speeduino firmware (45 x 58 mm)☆53Updated last year
- ☆15Updated 3 years ago
- 8Ch EGT sensor board to be used with aftermarket ECUs☆35Updated last year
- Sofrware to tuning ME7.xx Family☆13Updated 3 years ago
- Wideband Lambda Controller with Bosch CJ125☆45Updated 2 years ago
- An OLED gauge for the Speeduino ECU. Uses UART (secondary serial) for communication.☆40Updated 3 years ago
- An Arduino sketch for controlling a Bosch LSU 4.9 Wideband Lambda sensor with minimal parts☆85Updated 12 years ago
- Official Speeduino hardware designs☆238Updated this week
- Speeduino compatible m5x PnP PCBs☆133Updated 4 months ago
- ☆156Updated last week
- Wideband Lambda Controller with Bosch CJ125 and CAN-Bus Interface☆35Updated last year
- EMS boards powered by Speeduino☆12Updated 5 months ago
- Peak and hold injector driver for low-Z injectors.☆14Updated 3 years ago
- This is an open HW project of Electronic Throttle Controller also known as Drive By Wire.☆53Updated 10 months ago
- Standalone ECU designed for Speeduino and RusEFI firmware.☆54Updated 2 years ago
- Open source/hardware LSU 4.9 wideband controller☆18Updated 7 years ago
- Standalone ECU designed for Speeduino firmware☆42Updated 5 years ago
- Coil On Plug Project made with Arduino Nano V3 for Honda/Acura☆13Updated 3 years ago
- ☆44Updated 7 months ago
- Megasquirt Gauge using CAN bus.☆35Updated 3 years ago
- Gauge.S is all-car datalogger and development board.☆57Updated last week