Hell-Fire / WidebandO2Links
An Arduino sketch for controlling a Bosch LSU 4.9 Wideband Lambda sensor with minimal parts
☆84Updated 12 years ago
Alternatives and similar repositories for WidebandO2
Users that are interested in WidebandO2 are comparing it to the libraries listed below
Sorting:
- ☆155Updated 2 months ago
- Speeduino compatible engine control unit (ECU) based around black STM32F407VET6 board.☆52Updated 2 years ago
- ☆64Updated last month
- microRusEfi board for rusEfi ECU☆84Updated 4 months ago
- Wideband Lambda Controller with Bosch CJ125☆43Updated 2 years ago
- ☆25Updated 7 years ago
- EMS boards powered by Speeduino☆96Updated 3 months ago
- Hardware - dingoPDM is an open source, affordable automotive PDM (Power Distribution Module). Pre-assembled and tested units are availabl…☆98Updated last week
- 8Ch EGT sensor board to be used with aftermarket ECUs☆34Updated last year
- A class to read an ISO 9141-2 port found in car diagnostic OBD-II ports.☆317Updated 9 months ago
- Speeduino compatible m5x PnP PCBs☆133Updated 3 months ago
- STM32 based Arduino Mega replacement for speeduino☆112Updated 3 months ago
- Wideband Lambda Controller with Bosch CJ125 and CAN-Bus Interface☆34Updated last year
- Megasquirt Gauge using CAN bus.☆35Updated 3 years ago
- Hardware - CAN enabled small input / output expansion board. Switch panels, steering wheel buttons/knobs, etc.☆48Updated last month
- An OLED gauge for the Speeduino ECU. Uses UART (secondary serial) for communication.☆39Updated 2 years ago
- This is an open HW project of Electronic Throttle Controller also known as Drive By Wire.☆53Updated 9 months ago
- ☆44Updated 3 years ago
- Arduino ODBII ELM327 Emulator - Allows Arduino to act as an OBD2 ELM327 device and responde to PID requests☆68Updated 2 years ago
- DS2 K-line library for Arduino and ESP32☆51Updated 9 months ago
- Arduino / ESP / RPi Pico library integrating the proprietary VAG Key-Word 1281 protocol (KWP1281/KW1281)☆68Updated last year
- EMS boards powered by Speeduino☆12Updated 5 months ago
- Standalone ECU designed for Speeduino and RusEFI firmware.☆53Updated 2 years ago
- OBD2 K-line Reader (ISO9141 and ISO14230) with microcontrollers like ESP32, Arduino☆164Updated 2 weeks ago
- ECU designed for Speeduino firmware☆35Updated 6 years ago
- Official Speeduino hardware designs☆236Updated last year
- An open source TCM for Daimlers 722.6 gearbox. Resource repository☆122Updated last year
- Wideband lambda controller based on bosch cj125☆12Updated 6 years ago
- Arduino MCP2515 CAN interface library☆40Updated 5 years ago
- RealDash examples and technical materials☆171Updated this week