Alternatives and similar repositories for WBO2-Controller

Users that are interested in WBO2-Controller are comparing it to the libraries listed below

• Autohome2 / dxControl-Gears
  ☆22Updated 7 years ago
• oelprinz-org / BL49SP
  Wideband Lambda Controller with Bosch CJ125
  ☆39Updated last year
• ElDominio / CANforVAGME75
  CANBUS implementation for ME7.5 with Arduino Nano and MCP2515
  ☆20Updated 6 years ago
• ElDominio / ETC_Control
  Arduino Nano based ETC controller implemented with working states
  ☆10Updated 6 years ago
• dvjcodec / ECUTeen_3.5
  ECU designed for Speeduino firmware
  ☆32Updated 5 years ago
• bouletmarc / Arduino_Honda_OBD1_BM-Duino
  This is an Arduino Honda OBD1 ECU datalogger from CN2, also able to ignition cut
  ☆15Updated 8 years ago
• corygrant / CANBoard_FW
  Firmware - CAN enabled small input / output expansion board. Switch panels, steering wheel buttons/knobs, etc.
  ☆13Updated 3 months ago
• AmesisProject / 002-Amesis-Throttle_To_ThrottleBody_Arduino
  Order a motorized throttle body for gasoline engines with an electronic pedal and an arduino Commander un boitier papillon motorisé des m…
  ☆14Updated last month
• dvjcodec / SCG-ECU-2.0-STM32F407-8x8
  Standalone ECU designed for Speeduino and RusEFI firmware.
  ☆41Updated last year
• pazi88 / 8Ch-EGT
  8Ch EGT sensor board to be used with aftermarket ECUs
  ☆32Updated last year
• Tjeerdie / SPECTRE
  Speeduino compatible engine control unit (ECU) based around black STM32F407VET6 board.
  ☆50Updated last year
• ericmaas / speeduino
  EMS boards powered by Speeduino
  ☆12Updated 6 months ago
• Tjeerdie / Peak-And-hold-Driver
  Peak and hold injector driver for low-Z injectors.
  ☆14Updated 2 years ago
• TurboCorse / LambdaCtrl
  Wideband lambda controller based on bosch cj125
  ☆12Updated 6 years ago
• mck1117 / wideband
  ☆58Updated last week
• AmesisProject / AP_ME7.xxTunerMap
  Sofrware to tuning ME7.xx Family
  ☆13Updated 3 years ago
• BretStateham / arduino-ecu-simulator
  Arduino ECU Simulator
  ☆20Updated 6 years ago
• rusefi / rusefi_documentation
  User documentation for rusEFI engine control unit
  ☆37Updated this week
• rusefi / hw_microRusEfi
  microRusEfi board for rusEfi ECU
  ☆77Updated this week
• MWP / megasquirt-dash-display
  Dash display project for Megasquirt ECUs based on ESP32 and EVE2
  ☆32Updated 6 years ago
• corygrant / USB2CAN_HW
  Hardware - USB to CAN adapter
  ☆13Updated 3 months ago
• DStageGarage / WBOOS
  Wide band oxygen sensor controller - a tribute to 14point7 SLC Free
  ☆10Updated 6 months ago
• MielArrojado / speeduino-ardugauge
  An OLED gauge for the Speeduino ECU. Uses UART (secondary serial) for communication.
  ☆37Updated 2 years ago
• jankovalski / Speeduino-Serial-ESP32-TFT
  ☆13Updated 3 years ago
• bouletmarc / BM2Step
  Arduino based 2Step Launch Control Module similar to Bee*R for Honda/Acura
  ☆12Updated 5 years ago
• rnd-ash / ultimate_nag52
  An open source TCM for Daimlers 722.6 gearbox. Resource repository
  ☆116Updated 9 months ago
• rnd-ash / mb-w211-pc
  A fully custom infotainment system for my W211 E55 AMG based on a PC with a custom daughter board!
  ☆32Updated this week
• digmorepaka / speeduino-mini-2-channel
  A 75x78mm speeduino board featuring robotdyn mega 2560 pro microcontroller and all the basics needed to get a 2 channel setup. This is me…
  ☆13Updated 3 years ago
• merkur2k / MSCan_Gauge
  Megasquirt Gauge using CAN bus.
  ☆35Updated 3 years ago
• oelprinz-org / BL49
  Wideband Lambda Controller with Bosch CJ125 and CAN-Bus Interface
  ☆29Updated last year