smaeul / bouffalo-loaderLinks
Run an executable from RAM on a Bouffalo MCU (BL602 or BL808)
☆25Updated 3 years ago
Alternatives and similar repositories for bouffalo-loader
Users that are interested in bouffalo-loader are comparing it to the libraries listed below
Sorting:
- OpenBouffalo Firmware Repository☆39Updated 2 years ago
- A modern port of OpenOCD to WCH-Link RISC-V (see project wiki)☆22Updated 4 years ago
- Opensource embedded controller firmware for sipeed boards.☆44Updated 6 years ago
- OpenOCD source code for CH32V series MCUs released by Mounriver IDE☆55Updated 3 years ago
- SDK sch&layout reference design and datasheet documention☆69Updated 2 years ago
- ☆43Updated 4 years ago
- ☆25Updated 4 years ago
- Gateware to communicate with the high speed parallel interface (HSPI) of the CH569 with a FPGA☆33Updated 3 years ago
- fpga co-processor for faster SWD programming☆17Updated 8 years ago
- Opensource toolchain for BL602/BL604, BL702/BL704/BL706, BL616/BL618, BL808 and other series of RISC-V based chips from Bouffalo Lab☆27Updated last year
- WCH CH569 SerDes Reverse Engineering☆30Updated 3 years ago
- Datasheets and Reference Manual for BL602/BL808☆159Updated 2 years ago
- USB3 super speed development board useful as FPGA expansion based on WCH-Tech CH569☆27Updated 3 years ago
- ☆129Updated 2 years ago
- Siglent SDS1x0xX-E FPGA bitstreams☆44Updated last year
- USB-Blaster instance on CH55x MCU.☆54Updated 6 years ago
- Linux virtual Ethernet driver and utility enabling BL808 Linux to use on-chip Wi-Fi☆24Updated 2 years ago
- HydraUSB3 (WCH CH569) open source test firmware / examples / libraries to experiment with streaming / high-speed protocols (USB2 HS, USB3…☆89Updated 2 years ago
- Low-cost ECP5 FPGA development board☆80Updated 5 years ago
- usb-jtag - Altera USB Blaster Emulation with a FX2☆73Updated 3 months ago
- ☆24Updated 4 years ago
- AGM bitstream utilities and decoded files from Supra☆48Updated 5 months ago
- Example of ESP32-C3 (rev. 3 and later) "direct boot" feature.☆76Updated 2 years ago
- ECPDAP allows you to program ECP5 FPGAs and attached SPI flash using CMSIS-DAP probes in JTAG mode.☆72Updated last week
- Port of https://github.com/eleqian/WiDSO/tree/master/MCU/USB-Blaster to GCC and "traditional" STM32F103C8T6 Bluepill board.☆43Updated 6 years ago
- CH552 Dual USB to Serial Bridge.☆79Updated last year
- Example Makefile project for the CH32V307☆29Updated 3 years ago
- Documenting the Anlogic FPGA bit-stream format.☆88Updated 3 years ago
- ☆25Updated 5 years ago
- iCE40 FPGA, SPI flash, and CMSIS-DAP SWD programmer☆70Updated 5 years ago