corygrant / dingoPDMLinks
Hardware - dingoPDM is an open source, affordable automotive PDM (Power Distribution Module). Pre-assembled and tested units are available or the design can be used to build a DIY version.
☆97Updated last week
Alternatives and similar repositories for dingoPDM
Users that are interested in dingoPDM are comparing it to the libraries listed below
Sorting:
- ☆64Updated last month
- Hardware - CAN enabled small input / output expansion board. Switch panels, steering wheel buttons/knobs, etc.☆48Updated last month
- Free Open Motorsports ECU☆95Updated this week
- ☆22Updated 3 years ago
- Speeduino compatible engine control unit (ECU) based around black STM32F407VET6 board.☆52Updated 2 years ago
- microRusEfi board for rusEfi ECU☆84Updated 4 months ago
- LIN Example for CWA400☆15Updated 2 years ago
- ☆155Updated 2 months ago
- Official Speeduino hardware designs☆236Updated last year
- STM32 based Arduino Mega replacement for speeduino☆112Updated 3 months ago
- Wideband Lambda Controller with Bosch CJ125☆43Updated 2 years ago
- 8Ch EGT sensor board to be used with aftermarket ECUs☆34Updated last year
- EMS boards powered by Speeduino☆12Updated 4 months ago
- Standalone ECU designed for Speeduino and RusEFI firmware.☆53Updated 2 years ago
- ☆44Updated 6 months ago
- This is an open HW project of Electronic Throttle Controller also known as Drive By Wire.☆53Updated 9 months ago
- OpenPDM is an open-source programable Power Distribution Module for your car☆63Updated last year
- ☆25Updated 7 years ago
- EMS boards powered by Speeduino☆96Updated 3 months ago
- rusEFI open source lowcost CAN-bus dashboard☆20Updated last month
- An open source TCM for Daimlers 722.6 gearbox. Resource repository☆122Updated last year
- An Arduino sketch for controlling a Bosch LSU 4.9 Wideband Lambda sensor with minimal parts☆84Updated 12 years ago
- Speeduino compatible m5x PnP PCBs☆132Updated 3 months ago
- Wideband Lambda Controller with Bosch CJ125 and CAN-Bus Interface☆34Updated last year
- Open Source TS Compatible ECU Tuning Software☆34Updated this week
- ECU designed for Speeduino firmware☆35Updated 5 years ago
- Arduino/Teensy CAN Gauges with OLED displays☆16Updated 7 years ago
- Reverse engineering the Volvo VIDA protocol and CAN network to gather diagnostic information not available via OBD2 on Volvo cars.☆119Updated 3 years ago
- ☆44Updated 3 years ago
- ☆14Updated 3 years ago