Alternatives and similar repositories for z_extractor

Users that are interested in z_extractor are comparing it to the libraries listed below

• tom66 / scopy-fpga
  Application software for Scopy MVP: FPGA PS, PL, and microcontroller firmware
  ☆75Updated 4 years ago
• AnlogicInfo / anlogic-usbjtag
  A far more light version anlogic-jtag cable with some enhanced functions.
  ☆52Updated last year
• dukelec / cdpga
  FPGA core boards / evaluation boards based on CDCTL hardware
  ☆93Updated 4 years ago
• xjtuecho / AgmPill
  A low cost FPGA/CPLD dev-board based on AG1280Q48.
  ☆70Updated 4 months ago
• tom66 / scopeapp
  ☆30Updated 4 years ago
• AIOT-CAT / xvcd-ch347
  CH347 Xilinx Virtual Cable
  ☆27Updated 2 months ago
• tom66 / scopy_hardware
  Scopy MVP Schematics/Hardware Design Files
  ☆63Updated 4 years ago
• Floyd-Fish / Noise-Amplifier
  An ultra-low noise amplifier to measure low-noise LDO/OPA's wide band output noise, and many other interesting measurements. Referred to …
  ☆21Updated 2 years ago
• openzynqhardware / openzynq
  ☆40Updated 5 years ago
• XIVN1987 / Blaster
  Altera USB Blaster porting to Artery AT32F425 and WCH CH32V203.
  ☆25Updated 4 months ago
• tpunix / AGRV2K_go
  AGRV2K裸奔测试工程
  ☆26Updated last year
• xtoolbox / pcad2kicad
  Convert Altium Designer and PCAD library to KiCad
  ☆125Updated 2 years ago
• blueskull / PicoGate
  A tiny FPGA core module based on GW1NZ-LV1, CH552 and SLG46580
  ☆26Updated 3 years ago
• pbing / FM_Radio
  Simple mono FM Radio.
  ☆49Updated 9 years ago
• diodep / ch55x_jtag
  CH55x USB to JTAG bridge
  ☆139Updated 7 months ago
• Hello-FPGA / ZYNQ7020_Core_Board
  This is xc7z020clg400 FPGA hardware core board design
  ☆61Updated last year
• balmerdx / sdio_linux_fpga
  Communication channel from FPGA (Alterra EP4CE10) and Linux (Lichee PI Allwinner V3S)
  ☆28Updated 5 years ago
• Postlast / USB-Blaster_STM32f1
  The program for USB-Blaster Chinese version on STM32 works with
  ☆32Updated 8 years ago
• uwcms / ZYNQ-IPMC-HW
  ZYNQ-IPMC Hardware
  ☆17Updated 3 years ago
• kangyuzhe666 / zynq7010-pynq-2.5
  蚂蚁S9矿板移植pynq2.5
  ☆35Updated 5 years ago
• perehinik / Logic_Analyzer_PCB
  KiCad PCB project of Logic Analyzer
  ☆43Updated 4 years ago
• emoestudio / EmoePower
  A DIY Buck-Boost Power Supply for Laboratory works and personal use, based on LM5175 and ESP32.
  ☆19Updated 4 years ago
• DreamSourceLab / DSLogic-hdl
  An open source FPGA design for DSLogic
  ☆167Updated 11 years ago
• blueskull / CH552-JTAG
  USB-JTAG Adapter Using CH552
  ☆70Updated 3 years ago
• jankae / SpectrumAnalyzer
  It started as some general experiments with RF stuff and gradually evolved into a (severely limited) spectrum analyzer.
  ☆48Updated 6 years ago
• emoestudio / eEEExplore-2023
  电子工程相关技术交流讨论repo-2023年限定
  ☆22Updated 2 years ago
• Lichee-Pi / anlogic-usbjtag
  Binary blob for Anlogic USB-JTAG adapter (temporary), We should figure out much better solution next year.
  ☆18Updated 7 years ago
• DreamSourceLab / DSLogic-fw-keil
  Initial version of DSLogic-fw based on keil
  ☆39Updated 11 years ago
• PCB-Arts / zynq-feather
  Zynq-Feather brings the power of a Xilinx Zynq SoC (ARM + FPGA) into the compact Adafruit Feather form factor — enabling modular, high-pe…
  ☆49Updated 4 years ago
• HTCTEK / H7PI
  ☆19Updated 5 years ago