jwise / ndfslave
Tools to pull data off of a NAND flash chip using a Digilent Nexys-2 board.
☆31Updated 10 years ago
Alternatives and similar repositories for ndfslave:
Users that are interested in ndfslave are comparing it to the libraries listed below
- SD/MMC Analyzer for Logic☆45Updated 3 years ago
- 360nosc0pe Yocto build environment☆12Updated 6 years ago
- JTAG reverse engineering software for FTDI compatible cables☆51Updated 10 years ago
- SPI flash MITM and emulation (QSPI is a WIP)☆20Updated 3 years ago
- JTAG Hardware Abstraction Library☆36Updated last year
- Interface for exposing raw NAND i/o over UART to enable pc-side modification.☆20Updated 7 years ago
- Raspberry PI bare metal☆47Updated 11 years ago
- The Micro Python project (adding HydraBus Port)☆8Updated 3 years ago
- Utility for reading EnergyTrace data from TI debug hardware☆37Updated 3 years ago
- ESP32 projects☆29Updated 6 years ago
- uboot for Rigol DS1xxxZ Oscilloscope☆30Updated 8 years ago
- Emulates a Bus Pirate OpenOCD JTAG adapter with an Arduino Due☆48Updated last month
- SD/MMC Analyzer for Saleae Logic☆38Updated last year
- Experiments getting a Cypress FX3 SuperSpeed USB3 dev kit to behave as a logic analyzer.☆27Updated 7 years ago
- ☆20Updated 8 years ago
- USB Full-Speed (12Mbps) protocol analyzer for the DSO Quad☆21Updated 12 years ago
- FX2 EZ USB eeprom reader/writer for libusb☆29Updated 2 years ago
- Reverse Engineering of the Cisco HWIC-3G-CDMA PCB☆40Updated last year
- QSPI flash multiplexer - connect a SPI NOR flash to either an embedded system or a programmer for remote firmware tests☆50Updated 4 years ago
- NuttX port to Fernvale platform☆26Updated 8 years ago
- Chip support package for Cypress EZ-USB FX2 series microcontrollers☆76Updated last month
- Broadcom CFE Bootloader☆40Updated 2 years ago
- ☆23Updated 5 years ago
- GDB stub that allows debugging of embedded devices☆32Updated 9 years ago
- GCC for XAP☆15Updated 10 years ago
- Dump NOR/Parallel FLASH memory chips using an Arduino or Raspberry Pi☆43Updated 7 years ago
- Parse the programmable logic configuration of PSoC devices☆11Updated 7 years ago
- ☆51Updated last year
- Free Libre Open-Source/-Hardware JTAG/UART adapter based on FTDI2232H☆31Updated 8 years ago
- CANoolder: CAN to 3.3V logic level interface. Dumb. Cheap. Simple. Pick 3.☆13Updated 7 years ago