andreika-git / prometheusLinks
Prometheus board (See http://rusefi.com/forum/viewtopic.php?f=4&t=1215)
☆9Updated 5 years ago
Alternatives and similar repositories for prometheus
Users that are interested in prometheus are comparing it to the libraries listed below
Sorting:
- Free and Open Source MegaSquirt 2 Firmware☆16Updated 12 years ago
- ECU designed for Speeduino firmware☆32Updated 5 years ago
- A 75x78mm speeduino board featuring robotdyn mega 2560 pro microcontroller and all the basics needed to get a 2 channel setup. This is me…☆13Updated 3 years ago
- ☆41Updated last month
- *on hold * Implement J2534 interface with a cheep Chinese elm327 copy (pic18f25k80)☆18Updated 7 years ago
- Automatic Transmission Controller designed by Seaside Customs Garage☆12Updated 6 years ago
- Arduino library for interfacing Chrysler's legacy CCD-bus using the CCDBusTransceiver development board.☆19Updated 3 years ago
- MegaTunix Tuning software for MegaSquirt (and others) EFI Controllers☆55Updated 7 years ago
- Hellen-One Hardware Platform for rusEFI Engine Management System☆23Updated last month
- Order a motorized throttle body for gasoline engines with an electronic pedal and an arduino Commander un boitier papillon motorisé des m…☆14Updated last month
- Standalone ECU designed for Speeduino firmware☆39Updated 5 years ago
- User documentation for rusEFI engine control unit☆37Updated this week
- An electronic fuel injection program written in c++ to experiment with 1 us resolution on an Arduino, or STM32 Cortex processors.☆19Updated 8 years ago
- ☆22Updated 7 years ago
- Arduino Nano based ETC controller implemented with working states☆10Updated 6 years ago
- project arduino to clean solenoid injector of engin car☆24Updated 4 years ago
- ☆13Updated 3 years ago
- Open source/hardware LSU 4.9 wideband controller☆17Updated 7 years ago
- Speeduino compatible engine control unit (ECU) based around black STM32F407VET6 board.☆50Updated last year
- 8Ch EGT sensor board to be used with aftermarket ECUs☆32Updated last year
- The main trunk of FreeEMS firmware development from now into the future!☆27Updated 4 years ago
- Wideband Lambda Controller with Bosch CJ125 and CAN-Bus Interface☆29Updated last year
- Hardware is based off an open source project called Speeduino by Josh Stewart.☆15Updated 2 months ago
- blitzBOX - low-cost and mini-sized ECU for speeduino firmware (45 x 58 mm)☆48Updated 6 months ago
- Wide band oxygen sensor controller - a tribute to 14point7 SLC Free☆10Updated 6 months ago
- ECU using the MPC5634 processor☆11Updated 10 years ago
- ☆16Updated 6 months ago
- The MultiDisplay Project, An opensource datalogger, boost controller and display for cars☆36Updated 8 years ago
- ☆12Updated 5 years ago
- Development board for interfacing Chrysler's legacy CCD-bus (no CDP68HC68S1 chip needed).☆11Updated 3 years ago