Bylund / Lambda-Shield-ExampleLinks
Example code compatible with the Lambda Shield for Arduino.
☆21Updated 4 years ago
Alternatives and similar repositories for Lambda-Shield-Example
Users that are interested in Lambda-Shield-Example are comparing it to the libraries listed below
Sorting:
- ☆58Updated last week
- Hardware - dingoPDM is an open source, affordable automotive PDM (Power Distribution Module). Pre-assembled and tested units are availabl…☆80Updated last week
- ☆22Updated 7 years ago
- Wideband Lambda Controller with Bosch CJ125 and CAN-Bus Interface☆27Updated last year
- An Arduino sketch for controlling a Bosch LSU 4.9 Wideband Lambda sensor with minimal parts☆78Updated 11 years ago
- Hardware - CAN enabled small input / output expansion board. Switch panels, steering wheel buttons/knobs, etc.☆39Updated 2 months ago
- Speeduino compatible engine control unit (ECU) based around black STM32F407VET6 board.☆50Updated last year
- ECU designed for Speeduino firmware☆32Updated 5 years ago
- Megasquirt Gauge using CAN bus.☆35Updated 3 years ago
- Standalone ECU designed for Speeduino firmware☆39Updated 5 years ago
- EMS boards powered by Speeduino☆88Updated 7 months ago
- DS2 K-line library for Arduino and ESP32☆48Updated 2 months ago
- Wideband Lambda Controller with Bosch CJ125☆38Updated last year
- Standalone ECU designed for Speeduino and RusEFI firmware.☆40Updated last year
- 8Ch EGT sensor board to be used with aftermarket ECUs☆32Updated last year
- ☆18Updated 5 years ago
- Please find my custom Speeduino based ECU.☆18Updated 4 years ago
- LIN Example for CWA400☆15Updated last year
- Order a motorized throttle body for gasoline engines with an electronic pedal and an arduino Commander un boitier papillon motorisé des m…☆14Updated 2 weeks ago
- This is an open HW project of Electronic Throttle Controller also known as Drive By Wire.☆48Updated 2 months ago
- open-source ESP32-based control system designed to manage multiple outputs, monitor temperature, and provide robust control over external…☆16Updated 8 months ago
- An OLED gauge for the Speeduino ECU. Uses UART (secondary serial) for communication.☆37Updated 2 years ago
- Example code compatible with the Knock Shield for Arduino.☆14Updated 4 years ago
- ☆42Updated 3 years ago
- ☆124Updated 4 months ago
- microRusEfi board for rusEfi ECU☆75Updated 7 months ago
- Jetta TDI aux display☆18Updated 5 years ago
- Arduino Nano based ETC controller implemented with working states☆10Updated 6 years ago
- ☆40Updated 4 months ago
- CANBUS implementation for ME7.5 with Arduino Nano and MCP2515☆20Updated 6 years ago