stirobot / ESP32BoostAnimatedLinks
initial
☆13Updated 7 years ago
Alternatives and similar repositories for ESP32BoostAnimated
Users that are interested in ESP32BoostAnimated are comparing it to the libraries listed below
Sorting:
- ☆25Updated 7 years ago
- haha subaru wrx go brrrr☆45Updated 5 years ago
- This is an Arduino Honda OBD1 ECU datalogger from CN2, also able to ignition cut☆16Updated 9 years ago
- This repo for using your Arduino with MCP2515 CAN Interface and CANHacker software☆56Updated 4 years ago
- An Arduino sketch for controlling a Bosch LSU 4.9 Wideband Lambda sensor with minimal parts☆85Updated 12 years ago
- DS2 K-line library for Arduino and ESP32☆51Updated 9 months ago
- Megasquirt Gauge using CAN bus.☆35Updated 3 years ago
- ☆42Updated 5 years ago
- Car OBD gauges Arduino TFT☆25Updated last year
- VOLVO Driver Distraction Display :)☆66Updated 4 years ago
- Wideband lambda controller based on bosch cj125☆12Updated 6 years ago
- mcp2515 canbus module to Monitor Canbus traffic☆42Updated 2 years ago
- A DIY fuel injector tester based on an arduino and a mofset.☆21Updated 7 years ago
- Tunerpro checksum plugins for GM PCM files☆51Updated last year
- VNT LDA Controller☆18Updated 8 years ago
- Dash display project for Megasquirt ECUs based on ESP32 and EVE2☆35Updated 6 years ago
- Arduino firmware for Sardine CAN (Open Source J2534 device)☆88Updated 11 years ago
- ☆11Updated 6 years ago
- OBD2 K-line Reader (ISO9141 and ISO14230) with microcontrollers like ESP32, Arduino☆166Updated 3 weeks ago
- Wideband Lambda Controller with Bosch CJ125☆45Updated 2 years ago
- New version, looks like BC from Nissan GT-R and uses large touchscreen☆18Updated last year
- A simple Arduino sketch that allows you to send data to Torque Pro for Android☆28Updated 4 years ago
- Control Pioneer AVH-2330NEX Head unit with BMW E46 Steering wheel buttons. Plus some extra. (TH3122.4, ESP32, etc.)☆14Updated 5 years ago
- Arduino Uno powered OBD2 ECU Simulator 'Stand alone or qt5 GUI control'☆64Updated 5 years ago
- An OLED gauge for the Speeduino ECU. Uses UART (secondary serial) for communication.☆40Updated 3 years ago
- Modified version of PCM Hammer. Used to program calibration and OS or just the calibration section of 03-06 and 07 classic GMT800 instrum…☆37Updated this week
- FIS Control for the masses.☆51Updated 7 years ago
- Example code compatible with the Knock Shield for Arduino.☆14Updated 5 years ago
- 8Ch EGT sensor board to be used with aftermarket ECUs☆34Updated last year
- Arduino/Teensy CAN Gauges with OLED displays☆17Updated 7 years ago